It'll burn it if it dries out, the burn temp for cotton is about 430F
Fasttech Veterans
- Thread starter trouble1000
- Start date
- th_trl_thread_readers 0
- Status
I step my juice in various different ways.
Keep bottles in my airing cupboard for 14 days.
Hot water bath.
Caps and tips off for 24 hours.
Cap off and squeeze the bottle 10 or 20 times.
Shake vigorously for a few minutes.
I would steep my bottles in an ultra sonic cleaner but that popped and went up in smoke.
Do any of you steep your juice in any other way?.
Keep bottles in my airing cupboard for 14 days.
Hot water bath.
Caps and tips off for 24 hours.
Cap off and squeeze the bottle 10 or 20 times.
Shake vigorously for a few minutes.
I would steep my bottles in an ultra sonic cleaner but that popped and went up in smoke.
Do any of you steep your juice in any other way?.
Just leave it in the top part of my wardrobe, shake it then cap off, let it breathe for a couple of minutes a day and that's it
Serpent RTA: put the pre-built twisted on and wicked with some rayon 0.41 ohms, filled with Rejuiced-You Donut!
Why? did you read what it gives you? might be good for beginners but just icing on the cake for us
To upload the version and upgrade the device takes very little time and is very easy to do.
3 or 4 mins all in.
I`m the same as Sue and not used mine yet George
so it`s just a case of uploading to your pc then upgrade via usb ?
I`m the same as Sue and not used mine yet George
The advantage of the latest version Terry is you can use both + and - to alter the wattage in TC mode.
It is as simple as you say.Joyetech site,select your type of device in "support"and upgrades are at the foot of the page.
Thanks i`ll remember that if i get round to doing it
Just ordered 100 ml of LDL in 12 mg 10 ml of superstar circles in 6 mg and tried to get some sherpa, guess what OOS !!
Joyetech - almost all going back to their original tube style eVic
Smok - XCube & Mini
DNA200s - all
YiHi SX series - not all, some can only have the max power upped
HohmTech - Wrecker G2 only
there might be 1 or 2 I've missed
Bob, can you explain to me why i get a cracking vape with my 0.2 ohm builds at such low wattage ( 15 watts ) ? It`s got me baffled !
It doesn't mention the + & - keys bit in the "What's new", that why I said what I did, because all that was mentioned was that Smart Start for the Cubis & BF heads, what else has been updated/altered ?
Can you expand on that - Mod | Atty | wire used - and did you mean cracking (great) or crackling (noisy)
The new builds i did the other day, one for the Crius and one for the Bellus. 24 gauge wire, 8 wraps 2mm Dia=0.2 ohms, and cracking as in tons of flavour and vapour. I got the Crius on my IPV2, And the Bellus on my IPV d2. Just don`t understand how the vape is so good at such low watts.
- Status
Similar threads
