Looks good. I just got a few. Just haven't had time to start anything. Was it hard to solder to that outer + nut ?
No not at all. But it has bin brought to my attention that there mite be excessive voltage drop dew to no direct connection to + pin
It would be nice if the + pin was longer so the connection could be right on the + pin
that would be nice. Iv been thinking of drilling out the pin just a little bit more to insert an SS tube. Then you could solder right to the side of the brass pin.
Did you put a O-ring in the 510 to help seal it? Did it leak without it?
FD has a new BF option in the works, should be something much better then this from what I've seen, just have to see the final fab, so wait, this is definitely not what you want
It comes with an o ring on the brass pin no leaks
What does it entail? Why wouldn't I want this? Its better that what I'v been using. Madvapes 510 with a 14g blunt tip shoved in the hole.
Yes on the inside. But it looked like you had an O-ring on the top of the 510 as well.
And I see no drip cup. No leaking from the top if the 510 form the air slots?
I found that the 14ga needle didn't really have enough flow, I couldn't get juice thru it fast enough..What does it entail? Why wouldn't I want this? Its better that what I'v been using. Madvapes 510 with a 14g blunt tip shoved in the hole.
I found that the 14ga needle didn't really have enough flow, I couldn't get juice thru it fast enough..