So I got a vision blade because I liked how it looked. And the darn thing would fire about half the time (common problem)
so I went over the whole thing with a DVOM and micrometer I found that it does in fact fire every single time. But the 510 threads are really deep and the center pin is not all that secure so it gets pushed down. I was about to file it round, then I figured I might as well try to file it down before I tossed it out. I took about .60 mm off the top of the 510 threads now I have a good and solid connection at the mod to rda and it vapes fantastic now.
so I went over the whole thing with a DVOM and micrometer I found that it does in fact fire every single time. But the 510 threads are really deep and the center pin is not all that secure so it gets pushed down. I was about to file it round, then I figured I might as well try to file it down before I tossed it out. I took about .60 mm off the top of the 510 threads now I have a good and solid connection at the mod to rda and it vapes fantastic now.