First cotton build - Need some help figuring out which to do.

[DcMagic]

Hi all. So I have my meter and some 26g kanthol and I am ready to do a build.

I am using a sony vtc 5 battery and I think I want to do a sleeper build.

I was looking at the micro coil sleeper build by rip trippers on youtube, and he did it with 24g with 9 wraps each side, dual coil, out of 1 continuous piece of kanthol.

Here is the link to his video:
https://www.youtube.com/watch?v=xcKwOQzGLEU

I want to do the same thing but with my 26g. so I am trying to figure out what size drill bit I should use, and how many wraps to do that is going to get me around .3 ohms. (Or an ohm range that is going to give me the most vapor production)


I am still not too sure weather to go with a bigger bit, or more or less wraps to get the most vapor, and be able to do quick pulse hits.

Right now I am running 26g, dual coil, 3 wraps each side around some silica, and that is coming out to about .33 - .34 and I am not happy with the vapor production, I want to produce more out of my cotton build. So I could use some help.

Much appreciated.

 

[KC33]

I'd just do 5 wraps that should get you around there.

 

[juggalofisher88]

Acording to vapors toolbox app its for android get it if you can
6wraps around 1.4mm(1/16ish) or 5wraps around 2mm(5/64ish) or 4wraps around 3mm(1/8ish) all will get you close to .3ohms..
But if this is your fiest build, just know a sleeper is a pain lol I've noticed larger ID coils are easier to do a sleeper with so id start their after u get this down try a parallel sleeper whole other beast!
Good luck and post pics!
*Edit*
IMO smaller ID more vapor!
Get ahold of some 24g also you'll be in love

 

[ForeverDiving]

Mark this on your browser: Coil wrapping | Steam Engine | free vaping calculators