first ever micro coil

[gt58]

hey all, im a new member here and i was wondering if i could get some feedback for my first ever micro coil build. i believe its a 8/9 using 28 gauge. it came out to .7 ohms. i wrapped it on a 3/32 drill bit.

im using temco 28 gauge kanthal a-1 from ebay and peaches and creme ecru cotton wick from walmart. its on my fasttech sentinel clone and my igo w clone.

any tips or suggestions to make it better?

 

[StarDose]

I believe the fasttech igow only has one hole so will be best to drill out another hole if that is the case. As long as you gave no hot spots it should vape well, personally I prefer silica over cotton but to each their own.

This pic could be misleading but the coils look a little low, but as long as they line up with the holes you shouldn't have a problem.

Havent

 

[michgav90]

It might be that. Just a bit Low.

 

[Cr0tchF4i]

Fire that guy up, let's see it glow.

 

[gt58]

the pic is a little misleading i look thru my cap holes and see the middle of the coils. i drilled out both holes in the cap to 5/64 i believe

 

[StarDose]

I have a 1ohm micro on my trident from fasttech and can't imagine a dual micro since the single puts out a ton of vaper.

 

[gt58]

its a beast but i cant wait for my 26 gauge to come in to get it down closer to .3 or .4