I have found that I cannot use the iAtty on my TMF version with a re threader and 901-510 adapter. It does not make an electrical connection. However using the same setup, I can use it on my SS GGTS. The problem is that the center pin on the TMF is a few mm shorter than the one used in the SS version.
Also, the top of the 901-510 adapter does not go up high enough in the collector tank to allow the iAtty be completely screwed on. This allows the 2 little holes in the 510 connection of the iAtty to not be closed off basically preventing the collection tank from working properly.
Seeing as I use my UFS on the SS GGTS, I swapped out the center pins and it now makes a solid electrical connection.
I also used a small o-ring and put it at the base of the 510 connection on the iAtty to close off those 2 little holes... Now the collection tank works properly.
-Zor
Also, the top of the 901-510 adapter does not go up high enough in the collector tank to allow the iAtty be completely screwed on. This allows the 2 little holes in the 510 connection of the iAtty to not be closed off basically preventing the collection tank from working properly.
Seeing as I use my UFS on the SS GGTS, I swapped out the center pins and it now makes a solid electrical connection.
I also used a small o-ring and put it at the base of the 510 connection on the iAtty to close off those 2 little holes... Now the collection tank works properly.
-Zor
Last edited:
