For those Hadaly folks out there....Notch coils?

[Mojo Cho Cho]

Greetings Coil Builds board! I have a Hadaly coming my way that's going to be part of my first squonking setup (putting it on an hcigar VT Inbox that's on the slow boat right now). I was wondering just how much room you guys have found with it as far as coil builds go. I've been wanting to try a notch coil, but I'm concerned that they might be too big for the Hadaly. Has anybody ever tried one on this rda? If so, could you point me to the notch coil you used? If there aren't any notch coils that would fit in there, it's no biggie. My fused claptons that I usually use are more than enough to make me happy. Thanks ECF!

 

[badinfluence357]

Forget about the notch coil my friend. keeping in mind its a 22mm atty. basically it will flood with all the cotton you have to stuff in there for a notch coil.
The good news is that it produces good flavor and vapor with a single low gage coil.

You can also use a nice single coil clapton build but it pops to much causing hot drops of juice to burn the inside of you mouth. I dont recommend it unless your going to push the coil down close to the deck.

Sent from my LGMS550 using Tapatalk

 

[Mojo Cho Cho]

This was more of a question of "can I do it" rather than "should I do it" lol. What do you think about coils that are a bit less intense than a clapton? Twisted wire, tiger coil, etc.? Have you tried a spaced coil on there?

 

[stormjib]

spaced claptons work great. i don't think there is room for a notch coil to fit. the key is get your coil down as low as you can.

 

[badinfluence357]

Sent from my LGMS550 using Tapatalk

 

[r055co]

Not impressed with the notch coil, I run mine with a SS fused Clapton.

Notch coils IMO are just hype and a half assed attempt to get builder's back on the factory coil tit.

Sent from my Nexus 6 using Tapatalk

 

[Don29palms]

I agree that notch coils are horrible and a waste of money.

 

[bsidb]

I still like the Theorem with its notch coil

 

[pappasmurfsharem]

Sent from my LGMS550 using Tapatalk

That authentic or clone?

I had some issues getting a dual fused clapton to capture without going to either a really small gauge innercore, or standard clapton on the SXK Hadaly.

The little ledge where the wire would normally sit is a little short on the SXK clone.

 

[badinfluence357]

Its a clone. I'm running a dual micro
clapton in mine rite now..I took out one of the catches and just used the screw by itself to hold the wire. Like a sleeper coil.

Sent from my KFFOWI using Tapatalk

 

[badinfluence357]

I have the coils sitting kind of high but its wicking good. Its leaving the wick clean.....

Sent from my KFFOWI using Tapatalk

 

[badinfluence357]

Sent from my LGMS550 using Tapatalk

 

[badinfluence357]

Sent from my LGMS550 using Tapatalk