Hello
Today For SALE
Gepetto Art - "The Ghost" VV - With NEW ELECTRONICS
hand made wooden box mod with 510 connection that takes 2 16340 . It is carved out of a single block of wallnut and it has a chiseled one of a kind engraving.
Variable Voltage
Specifications for electronic components
Main features:
* Operated with one button.
* 2 digit, 7 segment 5mm LED display
* Powered by 2 stacked Li-Ion batteries ,Protected batteries are recommended.
* Works with 1.0 to 5.0 ohm coils
* 3,0V to 6,0V regulated, in 0,1V increments.
* Displays current power left with load and w/o load.
* Shorted coil indicator.
*Coil pre-heating function. Might come in handy on cold days or when we`re using thicker e-liquids.
- Eight pre-defined heating characteristics (A1 to A8)
- One heating characteristic that can be modified by the user (A9) (we can program up to 8s of heating in 0.5s periods)
- Programable cutoff time (5 to 15s)
- Button block - press it 4 times and then hold for more than 1.5s to block the button. Press 4 times again to unblock the button.
- Protection from overdischarging the batteries - you can choose when you want the mod to stop working (between 2.7 and 2.95v per battery [5.4-5.9v total] )
How to use it ?
When we insert the batteries the module is ready to work. We use the single button.
* If we have not used the switch for the last 3-4s, module goes into ‘sleep’ mode. LED display is powered down to save battery life.
* Normal press – Coil is powered up as long as we press the button. LED shows battery voltage under load. Shortly after we release the button, voltage w/o load is displayed. If we compare these two numbers we can see how good our batteries are and we can work out their internal resistance.
* Two clicks – Coil is pre-heating. PH will be displayed on our LED. This will heat the coil with ~35% of preset voltage. Pre-heating will finish after 4s and the device will go back to sleep mode. We can press the button at any time during the pre-heating process to end it and start vaping using our set parameters.
* Three clicks – Voltage increase mode. Each following click will increase voltage in 0.1v increments. When we set the desired voltage, we need to wait 3-4s for the device to save our settings.
*Four clicks – Voltage decrease mode. Each following click will decrease voltage in 0.1v increments. When we set the desired voltage, we need to wait 3-4s for the device to save our settings.
* Five clicks – Mode select:
- A1 – normal setting, just as with any other device
- A2 – Voltage will rise from 0.0V to preset voltage over the next 2s.
- A3 – Voltage increases to 120% of what we`ve set the device to for 2s and later goes back to preset value.
- A4 – Voltage will change fluently from preset value to 120% of preset and back in 2s intervals as long as we keep the button pressed.
- A5
- A6
- A7
- A8
- A9 .
I will update the electronics specifications later on
Price: 180$ With Shipping
PayPal only
Thanks