GGTS 801 Prototype mod
- Thread starter marathon
- Start date
- th_trl_thread_readers 0
- Status
Nice marathon, if you feel that the draw is not tight then its ok. You can also put an o-ring inside the channel between atomizer and GG.
I have also noticed on certain attys like the 801 depending on what type, be112, dse801, m201, etc. there could be too much air flow...but thats better then not enough, because like imeo said you can put an oring down there or foam, whatever works...
-Tim
-Tim
Yes the oring size you will need for this is 1/2"OD X 5/16"ID X 3/32" ... They fit down in there very well and can be used for the AFS also. Pull it out if you need to use the cartomizer unless you like a really stiff draw on the catomizer. I just tried it both ways and a cartomizer does work with the oring down inside.
vape, Thanks for the info, I'm going to pick me some up at the depot and/or lowes.
Yeah, I have noticed this small draw issue but had not said anything. I have found that for the most part BE112 worked alright but now with a small rubber thing in there (no oring yet) it works a lot better. The DSE801 seemed way to breezy ....to the point I wouldnt even use them. Im sure the oring will fix that problem. But, On other mods my problem with the Penstyle atty has been NOT ENOUGH air flow....and that is pretty hard to fix...lol. So I would rather too much air flow and be able to find a way to throttle back on the air...like a oring will do.
-Tim
Yeah, I have noticed this small draw issue but had not said anything. I have found that for the most part BE112 worked alright but now with a small rubber thing in there (no oring yet) it works a lot better. The DSE801 seemed way to breezy ....to the point I wouldnt even use them. Im sure the oring will fix that problem. But, On other mods my problem with the Penstyle atty has been NOT ENOUGH air flow....and that is pretty hard to fix...lol. So I would rather too much air flow and be able to find a way to throttle back on the air...like a oring will do.
-Tim
Yes I was looking for this to solve an issue with my AFS actually. I was not getting a good juice flow so I put this oring in there and wala... problem gone... back to normal. If I need to use the cartomizer I just pop it out. Plus this oring will stop liquid from getting down into that area that is hard to clean without taking out the atty connector all together. I have an 11mm socket that does that trick well. Unscrew the whole thing and easy to clean. I have to say at first this whole 4 in one thing was a little over the top but the more I use it I like it. Being able to use any atomizer without added length to the device is really nice. with this little oring trick and the update imeo is supplying us we should be good to go....
Last edited:
Yes Hefner, we can have 4 in 1 connector and adjustable draw too at the same time. For the 801 we need a second cap because 801 is fatter so we need a cap with bigger hole
- Status
Similar threads
