GGTS - AVS - UFS user manual

[Antong]

Antong, did you check the coil at the Odysseus and measured the resistance? IMO such symptons point to a short.

i tested it on a meter and its 1.2-1.3ohm. register Lo on the provari. its useable on other PV's though. but i dont use it on the GGTS im afraid that it might break the spring so i use it in my megalodon. if parts are readyly available here i wont hesitate on rebuilding one. but got no extra no res wires. if its shorting the taste would change right? but its just ohhhh so good... vapor is exelent. its just the warm to hot button. wanted to change the firing pin on the GGTS but still no stocks here. LOL.

 

[Antong]

Also are you using adapters or the GGTS base?

yah. i use 510-901 and 901-510 so i can put it in the GGTS. its like the empire state bldg. LOL. wanted to buy the stealth cap or the ody to GGTS base but there are no stocks here to buy.

 

[Zoranth]

You may want to take your Button completely apart and clean it thoroughly as you may find that to be the culprit.

i tested it on a meter and its 1.2-1.3ohm. register Lo on the provari. its useable on other PV's though. but i dont use it on the GGTS im afraid that it might break the spring so i use it in my megalodon. if parts are readyly available here i wont hesitate on rebuilding one. but got no extra no res wires. if its shorting the taste would change right? but its just ohhhh so good... vapor is exelent. its just the warm to hot button. wanted to change the firing pin on the GGTS but still no stocks here. LOL.

 

[Antong]

You may want to take your Button completely apart and clean it thoroughly as you may find that to be the culprit.

ohh ok ok. will try it later. do i just take it out and submerge it in vodka or do i need to take it all apart? and i think my GGTS is not firing at max voltage. i noticed that my megalodon is hiting better with the ody than the GGTS. sand down the battery connectors? or needs an upgrade? TIA!

 

[Zoranth]

Take the button completely apart and clean it. Sand the ends of the spring and also the axis of the spring.

ohh ok ok. will try it later. do i just take it out and submerge it in vodka or do i need to take it all apart? and i think my GGTS is not firing at max voltage. i noticed that my megalodon is hiting better with the ody than the GGTS. sand down the battery connectors? or needs an upgrade? TIA!

 

[Antong]

Take the button completely apart and clean it. Sand the ends of the spring and also the axis of the spring.

oki. thank you thank you! will do a full sanding job later.