It looks like 510 drip tip is native this time, and the glass drip tip will use an adapter. Basically the inverse of last time.
I have some custom acrylics for the v1 so I should be covered for both. Great to hear it's about same in height. I was wondering from the photo. It would be cool if they produced an option for the whole deck(single) with say room for a 3.0 mm coil wrap... Room for twisted, parallel, ect.. It's tight with the v1..just my thoughts
Oh nice! That's cool.. I did like the Cruis. I recently picked up a few and found a good vape from them. But I still like my g.mini's for swopping flavors during the day. Hoping the machining is better especially the tapping and screw fit. Don't like screws that drop down like theirs do(sloppy fit). Did you get one for review Dan?
Hah, no, I don't get products for review. I will be an early adopter on this one (goblin mini v2), as soon as I see a US vendor with the black in stock its going in my cart.
Completely agree. Love my v1, but hate having to take it off to fill, especially the way the dual coils tear through juice!
Maybe it's the goblin not the mini. I may have made a mistake when I looked online it said goblin mini, v2... I then went to him for utube...Sorry If I'm wrong. Im watching it anyway.
Try a kanthal build and use ko gen do or other cotton(resemblance) cut to strips(?). Instead of holding tails up above chimney. I found a different way of dressing the cotton. The cotton should be a little loose when pulling thru your coil(not too tight). I wet my fingers and twist the strip as I run it thru the coil. Have enough cotton tail to run part down the channel to bottom. Use 1/3 of that for channel the rest will go into the chimney. Run that 1/3(approx.)down the track and cut it slightly above the bottom. The other cotton you will trim so it doesn't overkill the chimney(too stuffed up). Trim the chimney cotton so it doesn't block off the airflow and brings some wicking. Place that cotton in a way that it's to the side of your posts. It sounds like alot of info but it's really easy. Just don't over cotton the tank and take your time for a couple of builds. Then you'll have it. Hope this helps. Anyway that's how I do it. Get good scissors (Dr.Slick). These make it so much easier to dress coils.
