Got my Cyclone today.A few questions

[paulw2014]

I just got my new Cyclone from IndyVapor today. I haven't had a chance to try it out yet, but upon first glance, I have a few questions.

1. I notice that the center hole for the Cyclone is noticeably bigger than my RM2. Does anyone know the dimension? Does it have any effect on your squonking? Right now I'm used to the RM2 and I wonder if the larger hole on the Cyclone would make it easier to over squonk.

2. There is a mini allen wrench that came with my cyclone. What is that for? Again, I haven't had a chance to take it apart yet (it's really tight, I might need to use a plyer to loosen the cap) but I'm assuming it's for the coil screws?

3. I'm a little surprised that my Cyclone didn't come with a drip tip. Is this normal?

Thanks guys.

 

[RattlerX]

1. I notice that the center hole for the Cyclone is noticeably bigger than my RM2. Does anyone know the dimension? Does it have any effect on your squonking? Right now I'm used to the RM2 and I wonder if the larger hole on the Cyclone would make it easier to over squonk.

Yes it will squonk easy

2. There is a mini allen wrench that came with my cyclone. What is that for? Again, I haven't had a chance to take it apart yet (it's really tight, I might need to use a plyer to loosen the cap) but I'm assuming it's for the coil screws?

The cap pulls off. Screw onto a mod and then pull cap off.It does not unscrew like the RM2. Yes the allen wrench is for the screws in the post

3. I'm a little surprised that my Cyclone didn't come with a drip tip. Is this normal?

This is normal. None of them come with drip tips

 

[Ropav]

I just got my cyclone today too! and that top was on tight! I had a hard time pulling it off. I stuck a little screwdriver in-between the two and light turned them apart

but I also have a question about the cyclone... all of my other drip tips don't fit in tight. are all cyclone drip tip holes a little bigger than normal? kind of annoying.. (sorry for the thread jack but you might have the same issue)

 

[Chowderhead1972]

If you think the ss afc is tight try the aluminum special Edition black,red,or blue. Even broken in with juice on the o-rings I can still torque the deck down without removing the cap.

 

[Borescoped]

Wow, you were able to score a BF cyclone AFC from indyvapor? Last I checked, they've been out... and looking just now, still out. They must have taken their time in shipping it to you.

 

[pauly3]

Yes I want a 2nd one. When did you all order?


Sent from my iPhone using Tapatalk

 

[POTENTCITY]

what drip tip fit these cyclones? could a drip tip I use on a patriot fit this?

 

[Ropav]

indyvaporshop found a small supply of BF cyclones and only had them up online for a couple of days.