GotVapes EXCLUSIVE WORLD PREMIERE - The VISION ETERNITY Rebuildable Atomier - AVAILABLE NOW!

Status
Not open for further replies.

mikecup

Super Member
ECF Veteran
Verified Member
Sep 9, 2010
772
376
67
Peninsula, Ohio
So far so good for me.
Dripping option: I put 20 drops in 70/30 the best flavor and TH from anything I have so far. Clouds of vapor.
I also tried the tank option, was just as good, but I am getting a slight plastic taste, I'm sure its the tank, I may try boiling them next time, they have been in storage for awhile.
No leaking at all.
I may order another or wait for some more new stuff. To many decisions:)
 

Scott_Simpson

Ultra Member
ECF Veteran
Verified Member
Jul 7, 2012
1,290
1,225
Fort Wayne, IN
I'm really enjoying my new Eternity ... like every other RBA I have—Penelope, Vivi Nova, Phoenix, etc.—this has its own unique learning curve, but it can deliver the goods as good as it looks. I've discovered that the same 3.5mm wick I use for my Penelopes is excellent for these. Also noted: the Eternity is apparently designed to be re-coiled with 36 gauge wire. I have both 33 gauge and 36 gauge Kanthal A-1, and the 33 gauge is just a hair too fat to let the little metal terminal clips seat fully on the terminal posts. The 36 gauge works a treat.

And speaking of those little metal terminal clips, I sure hope there are replacements available ... I've already lost one of the little buggers! Also would be nice if replacement soft silicone tank caps were also available; the two that came with my Eternity seem to be slightly different than those that I got with my original eGo-T Type A tanks.
 
Last edited:

Scott_Simpson

Ultra Member
ECF Veteran
Verified Member
Jul 7, 2012
1,290
1,225
Fort Wayne, IN
I'm also using my Eternitys on Twists, and I've found that just "snugging" them down (as opposed to torquing them down as far as possible), and then backing them off about a quarter of a turn, or even less, will give me a much lighter draw. I also use the decorative collar on the Twists; it not only smooths out the look, but the air vents in the sides of the collar also help the draw a bit.

Also, check to make sure your coil/wick has not "sagged down" enough to block the air tube, which is right between the two posts. IF the little metal post clips are not seated straight up and down, the coil/wick can sag a bit, which can block air flow. Do you experience any gurgling or leaking?
 
Last edited:

yiddleboge6

ECF Guru
ECF Veteran
Verified Member
Apr 25, 2012
16,850
94,508
PA
Status
Not open for further replies.

Users who are viewing this thread