Hcigar kayfun lite plus not firing on provari

Status
Not open for further replies.
It's not the screw. It's the length of the center post insulator. Adding a gasket to the screw will cause the screw head to protrude out more and will contact the terminal. You may switch out the insulator but the new one may not be any better. Try to save the insulator because they're hard to come by. I thought of using some thick bit of upholstery thread looped in an overhand knot under the screw head as a gasket. It may be easier than making a gasket out of scotch tape.
 

Knifemaker

Super Member
ECF Veteran
Verified Member
Jan 17, 2010
725
2,220
Central Texas
Had the same problem with my wifes EHpro light +
My HCigar is adjustable. Kinda handy!

I made a very thin washer from sheet brass and put it under the center pin screw head. Works just fine now.
You can find this sheet stock at any RC hobby shop.

Although most Kayfuns are not adjustable, the HCigar 3.1 is. I would have thought that the Light version would be as well. Have you tried it? It usually takes very-very little adjustment to make it work!:)

KnifeMaker
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread