Help Me Decide

[mackman]

I am looking suggestions for a well built tank for the Provari Mini. I don't know if I need one with the top fill hole screw or not like the AGR or X8. I want one that fits well with the Provari's diameter; so what 19mm or 22mm? And one that uses standard 35mm cartos? I don't want a huge tank 3 or 5 ml. What is the best material SS, aluminum or deltrin.

As for the cartos I only vape 100% VG juice. . What is the recommended/preferred resistance.

Accessories/tools: Do I need a tank tool like a Slap Yo Mama to protect the O rings when changing the carto? Is there a preferred carto punch should I decide to punch them? And who is a good vendor to buy the cartos from? I have seen some posts on bad cartos from turning over inventory to slowly or old inventory.

I am sure there are other important consideration I can't even think of but I appreciate all feedback.

 

[williebb123]

back when i used carto tanks i used the Lil Momma 3ml and xl cartos ( i liked a little bit of the carto to stick out the top of the tank) i used a dremmel tool to cut a slot just about 1/8 in above the bottom of the tank i felt the slotted carto helped to feed my 50/50 or 40/60 juice better

 

[Baditude]

 

[mackman]

what kind of tank is this?

 

[Baditude]

what kind of tank is this?

22 mm IBTanked, with Pro Rings (beauty rings) on the Provari.

Yes, if you wish to keep your tank's o-rings intact, you should use a tank accessory tool like the SYM. The following video demonstrates why. I also do not recommend hand punching nor slotting cartos. Hand-punched cartos become deformed enough to put stress on the o-rings each time the deformed area passes, and slotting causes sharp edges where the slots are to cut the rubber o-rings.