Hi Everyone. Having Battery Problem

Status
Not open for further replies.

Brisea

Full Member
Feb 22, 2013
6
1
54
Illinois
First off. Hi Everyone.

I started vaping at the start of the year. 1st with blu cig then upgrading to a joyetech 510, then to Ego twist. I recently purchased a Phoenix rba and I'm learning to rebuild it plus my atty's for my Viva Nova's. Using helpful tips on these forums I've had no problems at all with the rebuilds.

The problem I'm having with my Phoenix RBA is that it doesn't seem to get a connection on my Ego Twist. It gets power on my 510 just fine. Its like the ego battery just doesn't get a connection to it. I use a multimeter to check the continuity and the ohms so I know its built right. Unfortunately I'm not good enough to get the ohms perfect for the 510 and sometimes need the VV.

The Phoenix RBA is Phoenix Rebuildable 510 "Dripping" Atomizer

And Thanks everyone for all the helpful tips.
 

XfooYen

Vaping Master
ECF Veteran
Verified Member
Oct 11, 2012
3,035
5,032
SoCal
The Phoenix pin tends to get pushed up sometimes. Take a flat head screwdriver (narrow enough to fit inside the tank without ruining your coil) and apply firm pressure downward inside the Phoenix tank. This will push the positive post down a tiny bit and you will regain your connection. Don't screw down the phoenix too tightly and you can avoid this from happening again.
 
Status
Not open for further replies.

Users who are viewing this thread