House of Hybrids featuring the Zenesis PV

Status
Not open for further replies.

maleko

Ultra Member
ECF Veteran
Verified Member
May 8, 2012
2,362
5,920
Salt Lake City
Sounds like you're well on your way, Mal. Good job.

Sent from my Transformer Prime TF201 using Tapatalk 2

Makes me feel a lot better now that I nailed it on my first wrap and less intimidating for all the other Genesis mods I have on the way :laugh:

But on the ZAP I hear seven wraps is about where you want to be?
 

grruss

Vaping Master
ECF Veteran
May 23, 2012
4,388
9,121
Grand Rapids
www.mister-e-liquid.com
No no brunt taste now enless I go below 4 o'clock I think my juice is just a little thick lol

No wick is not touching anything. My coil is 5wraps and is vaping bliss ATM :toast:

What juice are you vaping? PG/VG content?

Sent from my Transformer Prime TF201 using Tapatalk 2
 

TexasPride

Super Member
ECF Veteran
Verified Member
Jun 9, 2012
829
1,455
Texas
I would wait a few days before changing to the tight draw.. You may be suprised how quick your "vape" changes..


No hot spots here vaping pretty good now :D

Only problem is I have to go to 2'oclock to get the wick wet and then vape at 3' oclock. Anything Else I get WAYYY burnt nasty taste :(
I think that might be cause I need to switch to 325 mesh?? I am using Ms.T's Sugar Cookie so not sure on the PG/VG ratio.

Other then that I think I might be on the prowl for a tight draw cap :laugh:

Ot
 

grruss

Vaping Master
ECF Veteran
May 23, 2012
4,388
9,121
Grand Rapids
www.mister-e-liquid.com
Gruss I am vaping Ms.T's Sugar cookie so ratio is a mystery

Tough to start not knowing. You already know that higher VG needs 325 though, right? I never tried that juice, but based on what you're saying, I'm guessing it's a higher VG content. Still sounds like you've been pretty successful tonight. Don't let Elfstone fool you. He's a rockstar.

Sent from my Transformer Prime TF201 using Tapatalk 2
 

cryptodogg

Ultra Member
ECF Veteran
Verified Member
May 14, 2012
2,012
3,076
Cornelia, GA
shaii, vapes bobas with 400. it should be ok i think

I'm vaping Pluid on the original setup in my ASH and it wicks fine, it starts out life as 50/50 before flavoring, so it ends up being a little less than 50VG.

I guess I am saying that the sugar cookie should be fine on 400 mesh. How thick is the liquid, difficult to pull into a syringe or fairly easy to pull?
 

maleko

Ultra Member
ECF Veteran
Verified Member
May 8, 2012
2,362
5,920
Salt Lake City
I'm vaping Pluid on the original setup in my ASH and it wicks fine, it starts out life as 50/50 before flavoring, so it ends up being a little less than 50VG.

I guess I am saying that the sugar cookie should be fine on 400 mesh. How thick is the liquid, difficult to pull into a syringe or fairly easy to pull?


Its a little harder to pull in the syringe I think its probably around 60vg
But currently I am liking it so I don't want to switch the mesh just yet!
I did roll a 325 for future though :D
 
Status
Not open for further replies.

Users who are viewing this thread