How to change flavors in phoenix top coil

[jfoster1]

I posted earlier about Phoenix tasting burnt, thanks to all that replied to that thread. If you want to change flavors in the cartomizer what would you do. I am guessing you take that top silicon cap that sits on the wicks off. Then you could wash it. Is that correct?

Thanks

 

[ThaHealer]

I typically just wait until my current fill is empty and then add the new juice. You can certainly clean it in between if you want to get the old flavor out. Allow the wicks to dry or do a dry burn before adding juice after rinsing it out.

 

[jfoster1]

How do you wash it out with water. Seems like you would have to take that top silicon cup out to get water in the chamber. I still have some juice in there and could not get it out unless I could wash it out. I was wondering can you take this whole little tube off the base?

 

[WallyO]

How do you wash it out with water. Seems like you would have to take that top silicon cup out to get water in the chamber. I still have some juice in there and could not get it out unless I could wash it out. I was wondering can you take this whole little tube off the base?

Don't mean to steer away from your question, but have you tried the Phoenix bottom coils? Awesome cart and so, so easy to clean.

 

[jfoster1]

Yea, that seems like the obvious answer. I went on thier site to order the bottom coils. they were out of stock and I was impatient. I ordered the top coils. If I try these again I will order the bottom coils.
Thanks for all the help everyone