how to "un-punch" cartos??

[solardrgn]

i realized i have many pre-punched cartos and i was wondering if and how people have been sealing them back up for use without a tank. i thought about putting tape, while putting something like plastic or more tape to cover where the adhesive would have covered the hole. any ideas?

 

[donnah]

Cut the end off of the condom and slide it ip over the hole.

 

[solardrgn]

i didnt think of that, sounds like it will work! thanks

 

[taxman32]

Seems like it would get too hot especially the way I hit them. But I've thought about how I could do it. Just haven't got that low on cartos to care yet.

 

[c.chalie]

soder it maybe

 

[MissP]

I just wrap mine in electrical tape Looks tacky, but works LOL

 

[solardrgn]

they're made of silicone right? silicone has an extremely high melting point

 

[solardrgn]

I just wrap mine in electrical tape Looks tacky, but works LOL

i thought about that, but i wouldnt want to vape the adhesive if it mixed...

 

[markfm]

If you want to solder, make sure it's lead-free. I expect a piece of condom would work fine, the outside barrel shouldn't be getting all that hot (maybe warm or hot to the touch, but not several hundred degrees).

 

[Dougiestyle]

Yep. Silicone. Cun the flat end off and you're left with a tube. It works. You can also vape the carto with the hole open. It increases airflow. Nicquid isn't gonna come seeping out, either. Most likely if you flood it, the excess will come out the connector end as usual.