I push a toothpick on the Bottom of the pod of the smok nord 2 device I think I did a small hole

[Adir]

So I just got my smok nord 2 for two weeks already and I wanted to clean my bottom pod I though about cleaning the rubber of with a toothpick and and was a bad idea to do it
I did a small hole in the middle of it
Do I need to worry about it and get a new one ?
Or it’s will still work and won’t do any problems to me

 

[PodVaper]

So I just got my smok nord 2 for two weeks already and I wanted to clean my bottom pod I though about cleaning the rubber of with a toothpick and and was a bad idea to do it
I did a small hole in the middle of it
Do I need to worry about it and get a new one ?
Or it’s will still work and won’t do any problems to me

Hi and welcome to the ECF,
From the picture i believe its the activation hole for auto draw, nothing to worry unless there are 2 holes as of now which then may leak eliquid into the device and break.

Perhaps you can check once again, If there is only 1 hole?

Be well.

 

[ImperfectFuture]

The pods are cheap, compared to a pack of cigs. I would just buy. I make my own ejuice for the pods (higher nic than purchased ejuice) have many pods on the side for Novo 2,3, and they last a long time. Closed pods, I do not try and clean. The Smok 50w has pods and coils (coils removable) that I can clean. Unless using .8ohm coil, I stick to 6mg and lower with the 50w pods, hence the Novos (close to your device) for the higher mg juice.

TLDR, buy more pods. For removable coils, buy extra pods and coils, but learn how to lean removable. Coils, rinse out hot water, place to soak in hot water and a little Isopropyl 99% or close. Rinse with Cold water, let soak, clean out with tiny bit of Kleenex (watch you tube videos before that). Pods, rinse in hot water, let soak, and then rinse again, air dry.

 

[ImperfectFuture]

Addition, I looked up your device, more close to the 50w.

I follow these videos for removables, there are more if you narrow the search: