IGO-S Mini

[unloaded]

Picked one of these little gems up at the local shop last night. First I'd seen or heard of them. Haven't had a chance to get any pics of it yet, but it is pretty small. About the same diameter as a Phoenix and half as tall. The posts are very close and things are tight. Gonna take a bit getting used to making coils for it. The top cap is held on with two orings like the big one. The "well" is very shallow, a small ridge around the edge, barely above flush. The orings keep it sealed, but removing top with juice in it will probably be messy. So far I'm diggin it, love the size and the vape is pretty good so far. I expect it to get better as I get better with the small coil. I used 2.5mm silica and 32g KA1 I'll mess around with different wicks and wires. I'll get a few pics up wen I can.

 

[unloaded]

Here are a few pics, sorry they are so bad.





Forgot to mention, got it from here:
https://vaporbank.com/shop/index.php?p=catalog&parent=197&pg=1
They don't have pics up yet and haven't even made them available but they will be soon.

 

[FunkyVapes]

Damn! Looks great, dude. Can't wait to see these on my side of the border

 

[calpis]

How snug is the top cap seal with the base? The Igo-L's top cap was real loose and needed some better o-rings to tighten up the fit.

 

[unloaded]

It's pretty snug on there so far. Gotta have it screwed on a mod to pull it off. I always pull my tips to drip and that's usually when a loose cap will show itself. So far it hasn't come off while removing the tip. Don't think it'll be knocked off either its so small there isn't enough leverage.

 

[snottyragsdale]

That looks like a Phoenix...got one for Yule, and as far as dripping sets up go that thing kicked like a mule!

 

[Jerms]

Sweet, I've been waiting for the release of this one, probably will make it my second RBA. How's the draw on it?

Sent from my LGL55C using Tapatalk 2

 

[unloaded]

Draw is just how I like it. The Phoenix draw is a hair tight for me, so I open the hole just slightly. No need to modify this one. The hole is pretty low though. Because of this, even though the orings don't leak, you can't throw a lot of juice in the bottom and wick it to the coil as you go, it'll come out the hole if you aren't careful.

 

[Xaria]

I picked up one of these last week. The O rings are much better, I can even dangle my mod by the drip tip and it will not come loose. The other difference is there are holes in the post versus none that was on the L version. It is a very tight fit so I have just been using a silica set up and haven't tried any mesh yet.


Sent from my iPad using Tapatalk HD

 

[9ball_AJ]

I am lovin' this little thing. Just made my first slug wick for it, not so pretty, but it's vaping pretty damn good!

 

[Quigsworth]

Can any one tell me if this will fit in the drip well of a Reo Grand?

 

[unloaded]

It might but its not for bottom feeders. The A7 mini will work and allow you to bottom feed.

 

[Quigsworth]

It might but its not for bottom feeders...

It will be when I'm done with it ...just looking for a new device to mod (the ERA drippers are easy to change to bf's, the igo s's look about the same)...I ordered a couple igo s2's from COV today, I can't tell what's different with the ver. 2 over the standard igo s but at 14.5mm diameter it should just fit a Grands juice well (I found out the diameter after my initial post).