? where is eveybody picking up the new mutank w/the two piece screw on chimney and base?
thanks in advance and a happy holiday to all
tonyc
thanks in advance and a happy holiday to all
tonyc
Indulgence Mt-Rta
- Thread starter 98ruby
- Start date
- th_trl_thread_readers 0
- Status
I'm really looking for the two piece chimney vs the press fit - I have the orig with the press fit - which separates quite easily ( such is every so often which is often enough)... Happy holidays to my Vape fam
️️️
Thanks in advance
Tony c
️️️Thanks in advance
Tony c
Tried one of the prebuilt heads that came with the mutank today, no burning or plastic taste but it tastes like soap. Maybe after they got reports of the early batches tasting bad they decided to wash them and not rinse them properly lol. Oh well, I only bought it for the RBA anyway and it is certainly one hell of a performer.
The two piece threaded chimney comes on the mutank. vapordna.comI'm really looking for the two piece chimney vs the press fit - I have the orig with the press fit - which separates quite easily ( such is every so often which is often enough)... Happy holidays to my Vape fam
Thanks in advance
Tony c
Sent from my Nexus 6 using Tapatalk
Thanks!!! Was trying to see if I have a screw driver anywhere to make a 3mm coil and was hoping I had one all along. Anyone know of a good store to pick one up? (e.g., Walmart, Sears, etc?)
Merry Christmas MTers!!! You guys have made my day numerous times! Love y'all!
Just buy one of the cheap screwdriver sets from the dollar store. I paid $2 for mine
Sent from my Nexus 6 using Tapatalk
Doh!! Thanks - I lack common sense sometimes (as was just painfully evident). If it is a screwdriver, will it actually say 3mm or does that refer to the diameter of the tip (be it phillips or otherwise)? I am assuming I want the measurement to refer to the shaft.
it is unlikely to give the shaft diameter; the number will be associated with the tip. Go and get a 3mm machine screw out of the hardware bin and eyeball it. Or use an 1/8" bit, as has been said.
After looking around for over a week now I'm gonna get a rx200. Im gonna call around and check local prices in the morning but more then likely I'll order one online. Where did you guys get yours from and how much was it? I think the cheapest I've found it for in the US was $45
Sent from my Nexus 6 using Tapatalk
Sent from my Nexus 6 using Tapatalk
I bought my wife's at Sweet Vapes, but it was $49.95
Wismec Reuleaux RX200 by Jaybo - Joyetech Wismec - Electronic Mods
Which she had in her purse when the strap broke, it hit the ground and rolled directly into a storm drain!!!
good thing she wanted the "pretty blue one"
Sent from my iPad using Tapatalk
I wasn't in a hurry and bought mine from Efun in China. It's already shipped and hoping it'll be here next week. They had it for $36, plus postage. This will make my 4th reg mod. I am thinking of getting either another MT or the Mutank. What's so different with the Mutank? I am really enjoying the heck out of my MT. I can't imagine it getting much better. And it looks like the Mutank is more expensive by $10.
I never use prebuilt coils anyway. I do like the velocity deck. I have a velocity on one of my mechs and I like it a lot. I might just wait to see what everyone else's experience is with it. Still rather partial to my MT.
- Status
