Really @Bman123 Really? Can I have a black one? Please, please,please?!Bman is going to give it to us
Indulgence Mt-Rta
- Thread starter 98ruby
- Start date
- th_trl_thread_readers 0
- Status
Bahahaha!
At $26.99, the 2nd 3rd 4th black tank is obtainable by all. I may grab another before months end! Figured I should wait a few days after my black MT and Bellus get here!
By the way when you guys say "Black" one do you mean o-rings or black metal?
Now I really want one! Where can one purchase such a beautiful thing?
Mine will be here today! Also grabbed one of these in black which will be here today too!Youde UD Bellus RTA Rebuildable Atomizer - $26.99 USA
My black one is at the post office near my house waiting to be delivered. Should be here any hour now. Rta hype!
Got mine a few days ago in black. liking it pretty well, but Im used to my Crown with a .25 head, and my TFV4 with the .15 quad. So far I haven't gotten a coil built that compares to either. I mad a pair of dual 22g 3mm 5 wrap coils, but havent installed them just yet. tried dual parallel 28G 3mm 5 wraps at .6 ohm, much more power than 35w and I started to taste scorched cotton, dual 26g 3mm 5 wraps at .33 ohm, same thing only at 45w. Im just not getting as much vapor as I do from the crown ad tfv4. I got spoiled on those tanks. I drilled a second hole in the top of it so when I fill it air can escape, and over all I like the thing a lot, but I am still trying to find THE coil setup that works for me. Only had leaking issues once, but youtubed it and found how to wick it and never had an issue since.
I have had it up to 65w dual 24g 2.8id .36resistance with fully saturated hits. Others here have doubled that.
So I'm having an issue with the post screws. I noticed my ohms jumping around so I tore it down to find 3 of the 4 post screws were loose. I was able to tighten 1, but the other 2 are just spinning. God I hope I didn't strip the posts. You guys know if there's any warranty available or should I contact the store I purchased from?
Replace the screws with better ones. The screws almost always strip before the decks.
D'jah get it yet?My black one is at the post office near my house waiting to be delivered. Should be here any hour now. Rta hype!
Thanks for the reply. Anyone know what size the screws are and where I can order them?
I assume local hardware stores won't carry this small of a size?
I assume local hardware stores won't carry this small of a size?
I'm on my way home from work now, I called the girlfriend though and it is sitting at my house waiting for me. I can't wait to get my hands on it. Now I just have to figure out what build to put in it. Any suggestions?
M2.5x0.45 seems to work pretty well for me. I replaced the stock screws with hex grub screws.
Third MT arrived today (black this time) along with some SSV Ti wire.
Built dual 3mm id 7 wraps net .12 ohms. Put it on a Lavabox at 480 degrees and the vape is pretty darn good!!
This is the first RTA temp build I've tried because all of the other decks seemed too small.
Not the MT!!!
Built dual 3mm id 7 wraps net .12 ohms. Put it on a Lavabox at 480 degrees and the vape is pretty darn good!!
This is the first RTA temp build I've tried because all of the other decks seemed too small.
Not the MT!!!
- Status
