Ipv4 upgrade available

[Thor Cloudchaser]

I don't build that low, sorry.

 

[ka724ka]

Does anyone know if they lowered the lowest resistance too? Im hoping for .08 instead of .1.

Edit:
Nope it sure doesn't.....

i am using 0.08 dual Ti coils. temp set at 420f and 60J

 

[sos2001]

I'm pretty sure the ipv4 will fire down to 0.05 in Joule mode. I've built a dual coil @ 0.065 and it fired it with no problem.

 

[Thor Cloudchaser]

I'm sure he is referring to going lower in power (wattage) mode my friends...

 

[J-Red045]

I'm sure he is referring to going lower in power (wattage) mode my friends...

Yes sir, sure am. I should have probably clarified. Now that TC mode with Ti goes up to 100/120 I'm kinda wondering how bad it would be for the chip if i ran a .08/.09 nichrome build in TC Ti mode. Its got bad idea written all over it so I just don't wanna find out.

Its not that I find it entirely necessary to go <.1 just for the sake of the number but a lot of the time Ill make a build like a double twisted fused clapton with 26 helix and it'll turn out awesome but i cant fire it because it'll be like .01 measly ohms under .1 and it drives me irate lol, all that work and no dice.

 

[chopdoc]

I tried everything suggested and I cant get past device not found. Even have one cable connected to the back of the PC and one cable connected to the front of the PC.

 

[themightyturtle]

Same thing happened to me on several different computers. It was not detecting my device even though the IPV4 was connected with a USB cable. Finally I searched Windows help. Went into Control Panel settings-> Hardware and Sound-> Devices and Printers-> Add a device. Once the laptop recognized the IPV4 device I could install the USB driver and perform the firmware upgrade. Good luck!

I tried everything suggested and I cant get past device not found. Even have one cable connected to the back of the PC and one cable connected to the front of the PC.

Uhhhh...add device.

 

[Wraith504]

I tried everything suggested and I cant get past device not found. Even have one cable connected to the back of the PC and one cable connected to the front of the PC.

And you installed the sxi update software? not the actual update file?

 

[chopdoc]

And you installed the sxi update software? not the actual update file?

Yes, the SXi software wont recognize it either and searching for new device wont recognize it.

 

[chopdoc]

ok guys, here is a weird one. I have 2 IPV4's. Decided to connect both of them at the same time, added device and it recognized it. One of them upgraded, the other still wouldnt connect. Any idea's? Bought it late may but no idea what happened to the reciept.

 

[Wraith504]

ok guys, here is a weird one. I have 2 IPV4's. Decided to connect both of them at the same time, added device and it recognized it. One of them upgraded, the other still wouldnt connect. Any idea's? Bought it late may but no idea what happened to the reciept.

Strange... just try again remove batteries connect device open sxi click install driver