Ithaka official

Status
Not open for further replies.

Alireza355

Senior Member
ECF Veteran
Verified Member
Sep 27, 2012
99
52
Phoenix, AZ, USA
Ithaka works the same with all juices Ali my friend. This small gurgling comes from the adjustable post that holds a tiny quantity of juice. If you use GGTS then remove the adjustable pin and check again.

Also, you can take 5-6 quick and hard inhales without pushing the button or blow air via mouthpiece and gurgling will leave

thank you for your response imeo. i have checked, there is no liquid in the adjustable center pin. the liquid causing gurgling is inside the ceramic area and i can shake it out using your method, but i would like to know how to a avoid having the slight flooding in the first place.
 
hi imeo, i am getting this little gurgling/little flooding on my ithaka, even though i have the liquid control always closed and only using the basic feeding, and i have the ceramic bottom holes visible to feed the flooded juice back to the wicks... can you help me out? does it have anything to do with the pg/vg ratio? i'm using 70/30

Is it possible your basic feeding is on both wicks? Could be causing slight flooding?
 

RiverNut

Ultra Member
ECF Veteran
Verified Member
Jun 1, 2012
2,639
3,353
Texas
hi imeo, i am getting this little gurgling/little flooding on my ithaka, even though i have the liquid control always closed and only using the basic feeding, and i have the ceramic bottom holes visible to feed the flooded juice back to the wicks... can you help me out? does it have anything to do with the pg/vg ratio? i'm using 70/30

I use a thin liquid too and think that it's best if you do not use basic feeding. I open my juice control for a few seconds then close it for a few vapes. This gives me the most control over wick saturation.
 
I cant really tell DH my friend. But somehting is wrong there.

Its all good. I was so excited that I slapped this bad boy together in record time. The bit of condensation is alright. Will take it apart and recheck everything when I finish this tank. Should have payed a bit more attention to everything and may not have had the issue.

I am deeply impressed by the Ithaka, not only is it stunning to look at, it is a work of art. The high attention to detail really shows. I will be seeking more in the future for sure. Imeo, the Ithaka is truly your best work thus far and I do believe your signature in that you "will satisfy every vaper out there." Words can not describe the pleasure it brings in the 2 hours I have had it. I can only say that the quality of your work is never short of 110%. Your work ethic is simply amazing.

I received my first GG product around a month ago. I now currently have 6 of your products. I am a huge supporter of your work and am hooked. I have never had a better vape.

You sir have created God's vape.

I applaud you on your accomplishments with the GG product line, and lastly thank you for your support on the forums and for satisfying this vaper.
 

jmarkus

Ultra Member
ECF Veteran
Verified Member
Mar 3, 2011
1,387
1,126
53
CA USA
got my ithaka, threw together a quick coil, rather sloppy cuz i was heading out to work. 2ohm single coil with X 2mm wick. works amazing, even with a quickly thrown together coil. havent had a dry hit yet, havent had to open the mp feeding, bf works brilliant, taste is amazing. cant wait to start playing with different setups.

once again, imeo, you've killed it...so glad i got in on the ithaka. thank you thank you thank you!!
 
Last edited:

kwalka

Unregistered Supplier
ECF Veteran
Jan 23, 2012
3,581
4,536
Clearwater, Florida
walkers-finest.com
Ithaka #904 is home.
I set it up with single coil, dual wick. I used a paperclip between the wicks when I wrapped the coil. I could not get a reading from the meter. I have built Ody hundreds of times... Opened it back up and adjusted the neg connection, with it on the stealth and it is now firing. I have it filled, the BF is fully closed as I am used to opening the juice control. I do not have a lot of time to experiment right now.
The vape is GREAT! Flavor, TH, and vape production are outstanding.

As a Ody master, I will say I can see why people are having issues setting this up. There is a learning curve to this. The extra components are sure to confuse. If I set it up wrong the first time, anybody could.

I have not looked to see what tutorials are out there, I have tried to stay away for obvious reasons. There need to be some setup videos done like the Scott did w Ody, to show the noobs exactly what goes where.

Imeo,
Thanks for this beautiful piece of GG art. It is a very well engineered, thought out combination of everything you have learned thru the years on what a perfect atty should be.
I wish it came to me under better circumstances, but as usual, your craftsmanship outshines any black cloud that rained on us.
Ken
 

BmoreJeff

Senior Member
ECF Veteran
Verified Member
Feb 23, 2013
284
128
Baltimore, MD
just got ithaka in mail today, it looks great. imeo, im sure you already answered this question but when will extra ceramics be available? i wont let ithaka leave the house until i have back up ceramics in hand just in case it gets dropped. also how about the drip tip mouth piece and extra rebuildables, when are they due to be available? thanks again for ithaka
 

glauserjg

Super Member
ECF Veteran
Verified Member
Aug 16, 2012
683
286
40
buffalo,ny
Your posts are killing me guys!!! You make a very happy person!!!!!!

Imeo my friend,


I own or have owned basically every high end atty that has been available; I can honestly say Ithaca outperforms them all in every aspect! I have tried over 5 different builds and it never lets down. You have engineered the pinnacle atomizer of the vaping world. I am sure it wont be outdone until you decide to make something to do it!!!


Many thanks for this perfect product

Jon
 

imeothanasis

Unregistered Supplier
ECF Veteran
Feb 13, 2009
47,882
34,510
Athens, Hellas
gg-goldengreek.com
With the next batch of Ithaka Jeff that is in about 2 months. But ceramics will be available in about 15 days:)
just got ithaka in mail today, it looks great. imeo, im sure you already answered this question but when will extra ceramics be available? i wont let ithaka leave the house until i have back up ceramics in hand just in case it gets dropped. also how about the drip tip mouth piece and extra rebuildables, when are they due to be available? thanks again for ithaka
 

imeothanasis

Unregistered Supplier
ECF Veteran
Feb 13, 2009
47,882
34,510
Athens, Hellas
gg-goldengreek.com
I thank you too glaus. I dont own any other atomizer except a China made one that Vasilis gave me. So I cant compare Ithaka with the others, so I am based on your opinions to tell me what is going on. So when I read post like yours, I know that we made something really special and I too believe that Ithaka will take a separate place on vaping world. And after the telescopic mouthpiece that will give us the ability to make it longer or shorter and give the ability to Ithaka to be longer or shorter, we will have made the ultimate vaping construction I hope
Imeo my friend,


I own or have owned basically every high end atty that has been available; I can honestly say Ithaca outperforms them all in every aspect! I have tried over 5 different builds and it never lets down. You have engineered the pinnacle atomizer of the vaping world. I am sure it wont be outdone until you decide to make something to do it!!!


Many thanks for this perfect product

Jon
 
Status
Not open for further replies.

Users who are viewing this thread