Its woodvil time

Status
Not open for further replies.

redeyedancer

Unregistered Supplier
ECF Veteran
Feb 4, 2010
15,547
58,185
57
Maine
WOW.....just WOW....I can't think of anything else to say.....Rob, you are the SHIZZZZNIT!!!!! I wish I had a tenth of your talent.
Any word on the milled catch cup on these stunning beauties!!??!!
I have no plans to mill the juice well down on this run . There are multiple rbas that will work with these juice wells era the igo- bf rm2 chalice . When I build the next lot of mods they will have low profile drip wells setup for sub ohm
 

Treebeard

Ultra Member
ECF Veteran
Verified Member
May 27, 2013
1,333
5,788
Downtown Shufunkdeville

Filthy-Beast

Vaping Master
ECF Veteran
Verified Member
Jan 14, 2011
7,133
28,702
Chicago

Treebeard

Ultra Member
ECF Veteran
Verified Member
May 27, 2013
1,333
5,788
Downtown Shufunkdeville

ChrisEU

Super Member
ECF Veteran
Verified Member
Nov 23, 2011
686
1,928
Germany
I have no plans to mill the juice well down on this run . There are multiple rbas that will work with these juice wells era the igo- bf rm2 chalice . When I build the next lot of mods they will have low profile drip wells setup for sub ohm

Plus, the woodvils have electrical switches. I am not sure what the specs of those are, but most switches in that size and depth are specced for 3A, more expensive ones can take 5A. Sub Ohm is out of the question with that. Even if it might hold a while, high currents will fry the contact areas inside the switch sooner or later.

My non-VV Woodvil 18490 doesn't see anything lower than an Ohm, and that's pushing it at 4A.
 

nerak

ECF Guru
ECF Veteran
Verified Member
Feb 12, 2011
25,335
60,415
Fairfield Township, OH, USA
www.facebook.com
So, if I have a block of wood I would love to have a mod made from, Rob does that?! :banana:

Robert use to do custom orders. If you read the first post in this thread you will see that now he is not doing them.

Only time will tell if he would take custom orders in the future.
 
Status
Not open for further replies.

Users who are viewing this thread