Juice spitting from coil while vaping from PT2 - Normal?

[EL Pistoffo]

A behavior that I have found to be common from stock kanger heads and even from microcoils to a lesser extent is juice spitting or splattering into mouth while drawing. When I draw in, I can hear the crackle of the juice as it's heated but the louder the crackle, the more juice I feel splattering on my tongue. Is this common or normal? Even my microcoils tend to do it sometimes but not as much. The flavor is definitely more intense when that happens.

This has been the case for so long I've kind of ignored it but now I'm kind of annoyed by it.

My equipment is 4 mini PT 2's. Some stock coils-2.2 and 2.5 ohm. Microcoils, 1.6 -2.2 ohms. MVP2 and eGo VV running 3.8 - 4.1v. Cotton wicks.

 

[LX1X]

Normal..

If spitting to much.. It may be flooded. Or try dropping the voltage a notch or two..

 

[EL Pistoffo]

Normal, Cool.
It's not flooded, no gurgling when taking dry hits. I've had flooding in the past, definitely not that.

 

[BuzzKillBob]

i just got on here about the exact same issue... im using the pt2 with 2.2 coils on 3.7 volt ego 650mah battery... ive had flooding before as well and thats not what this is(at least in my case) i just got this tank today and ive had to blow it clean about 4 times already... works good for 10-20 good long drags but then it starts spitting at me again...

 

[BuzzKillBob]

anyone got any ideas on how to fix this?

 

[Mrs C]

adding a tad bit more cotton to the flavor wick usually stops it for me

 

[BuzzKillBob]

adding a tad bit more cotton to the flavor wick usually stops it for me

how i add cotton to these quick change coils? i a bit confursed...

 

[chalupacobra]

Sounds like too much juice flowing in. Is your juice very thin? Try higher Vg content.


Sent from my iPhone using Tapatalk