Just about done

[TDM]

I get hard draw and poor quality taste on my Prodigy. Usually every day or two, I clean the atty with Ever Clear - 190 proof pure grain alcohol. The performance returns to "normal", and the liquid taste great again. I seem to average about two weeks of use on an atty before it is shot.

I use an 801, I think the large reservoir gets kinda "gunked" up after a full day of vaping.

If your dripping blow the atty out every hour or so. Mine gets a real hard draw and that helps alot.

 

[Robert]

Does anyone know which resistor Prodigy is running- A resistor takes battery power and makes heat- heat ruins switches, melt thing etc.

Are they really using a resistor? I would like to see the specs on it.

Instead of a resistor I'm using an inline voltage regulator- it pulses on/off at 32 times a second. Perfect 5.01 with low drop out.

CR2 say 3.0 volt but full charge they are 3.6 so times 2 = 7.2 volt
CR123 come in 3.0 and 3.7 so they are really probly 3.6 and 4.0 so time 2 could be 7.2 to 8.2volts

You can allways do what Crash did and cut it apart with a hacksaw.. Take it apart and look at it probly just a loose wire or bad solder connection somewhere.