Just got my Provari in and have a question about an error with one cartamerizer.

[steved5600]

Just got my Provari in. When I use my first Cart I get an E1 error saying it has a shot. Is that because the resistance is lower than the ones that came with it? The ones that came with it do fine at the higher voltages. When I lower the voltage it works on all of them.

 

[LongHaul]

Turn down the power as I am guessing it's a dual coil it's a common problem the provari don't care for dual coils


Sent from my truck using 3 toasters a broken microwave and 6 rubber bands McGyver style......Chuck Norris aint got crap on me

 

[steved5600]

Turn down the power as I am guessing it's a dual coil it's a common problem the provari don't care for dual coils


Sent from my truck using 3 toasters a broken microwave and 6 rubber bands McGyver style......Chuck Norris aint got crap on me

Thanks. I use to be an Electronics Tech before becoming a Computer Nerd. Figured it was something like that but since I'm a FNG figured I'd better consult the Vets. Just got into the Kid at Christmas mode.

 

[imevh2]

Turn your volts down to 3 and then check the Ohms on the Provari. 13 clicks on the button will get you to "Ao" If it says 1.3 or 1.5 it's a lower resistance carto. If you're running your volts higher, it'll give you that message. I had that problem early on when I ordered the wrong carto's. And yes, it doesn't like dual coils.

 

[dome]

Probably you have too many volts for your resistance..

 

[steved5600]

Turn your volts down to 3 and then check the Ohms on the Provari. 13 clicks on the button will get you to "Ao" If it says 1.3 or 1.5 it's a lower resistance carto. If you're running your volts higher, it'll give you that message. I had that problem early on when I ordered the wrong carto's. And yes, it doesn't like dual coils.

Dead on. Thanks. THe Ao was at 1.8 the other fried.. I will have to get some higher resistance carto's.

LOL it fried my Ego T vape at 5v but it was my oldest. About 2 weeks old

 

[Mrmorbidthoughts]

Roo much POWA

 

[ThunderFli]

I have to set my provari to around 4 watts to work with the dual coil cartomizers. Kind of a pain, but I bought a bunch of those cartomizers so I'm stuck for a bit!

 

[Dr33m]

Got to check those ohm's every time. I have seen that most of the time what is advertised is not always the actual. I've seen 1.8 ohm cartos read 2.6 and I've seen 2.4 cartos read 1.3. I poped a few before I learned to check every new one I put on.