Just got my snp

[sss1911]

I apologize if this has been brought up.

I just got my snp. For the life of me I can't get my ikenvape fusion cartos to wick properly.
Also it may just be a few dud cartos but I can't get one of the holes in the laser cut cartos to wick.

Any advice is appreciated.
What are y'all using inside yours.

 

[jetcity]

I use Boge (2 hole laser punched) in my SnP and all my tanks. I'm probably in the minority but I like them better than ikenvape. You probably just got a bad one though... if you primed it well and it's not wicking.

 

[glassgal]

I don't have any ikenvape cartos because I bought sooo many boges I have to use up first, but did you try dry sucking with the drip tip on to make sure it's fully saturated before firing it up?

 

[Krint]

I just got a bunch of the ikenvapes I have gotten a bunch if duds. Like yours they don't wick right I am going through 1 in a day right now and am vaping 50/50 clear juice.


Sent from my iPhone using Tapatalk

 

[sss1911]

Yeah my juice is pretty clear also. And yes it was very saturated.

 

[Krint]

Yeah I would try another carto or if you have a punch try making the holes bigger or even make another hole.


Sent from my iPhone using Tapatalk

 

[Spydro]

I punch the wimpy pre lasered holes bigger in my cartos, and prime them by dry sucking when installed in a filled tank. I'm pretty new to using carto tanks because I have never liked cartos at all, and know that I don't follow the system most folks use pre priming with condoms. Has been working just fine for me without the extra bother/mess. But I have started switching to Sophia atomizer's in those carto tanks I will actually continue to use, and will probably retire the rest once the "re" punched cartos are used up. I'm just more into the rebuildable atty's, drippers and those with a tank. Today it's been an eBaron dripper rotating liquids all day on the polished ProVari. Together they make an incredibile flavor, throat hit and vapor machine.

 

[Stormy1960]

I am not having any problem with mine and I use 100%vg... I had lots of problems at first because I was not letting them saturate enough..I have also noticed that they don't wick as well in certain tanks.

 

[sss1911]

What I just noticed about them is that there is no space between the holes and the bottom cap of the tank. I don't know if that may be the problem or not.

 

[jwj63]

I have an Ikenvape in my SnP ATM. It works fine. A couple of things to look at. 1) The IKenvapes have some sharp edges on them. Did it carve up the o-rings while you were inserting the carto? 2) Is the top cap all the way tight so as to seal up the fill holes? A good vacuum in the tank is required to make them wick right.

 

[darkgear]

You can actually use the vacuum created by the tank to help prime cartos. Take the SnP and push it all the way down to the top of the Provari. You should get no airflow. Now if you suck without firing it forces juice into carto and you can prime the cartos faster. If you have the 22mm SnP, it'll fit in the IBT thingy and you can use that to prime the carto too.