Just what end to blow out.......

[Zbeast08]

Ok, just hear me out!! I have read several threads tonite about using carto/atty for dripping and sampling juices. I have read to blow out the old juice or the primer from the threaded end out to the drip tip and I have read to blow out from the drip tip and out the threaded end! What is the correct way to blow out the 510?? Please clarify for me as I have purchased some 510 Boge's and some Cisco atty's as well.

 

[PEneoark]

Blow from the threaded end and you should be good

Sent from my SGH-I747 using Tapatalk 2

 

[Steam Turbine]

I read the same:

-Do it like this!

-No do it like that!!!

You know what? I don't really think it matters.

You blow:

Juice goes out.

One way or another.

 

[circusmonkey61]

Thats what she said Steam!!!

 

[BigLebowski]

You should blow it out from the threaded end.

 

[The Ocelot]

There are some tips here:

Drip, Drip, Drip…

In through the threaded end, out through the mouth piece. Think of it this way: the whole point of "blowing out an atty" is to blow as hard as you can to get any primer/liquid out. If you blow hard into the mouth piece, the air is being forced down to the little hole at the bottom connection end. The pressure might damage the coil.

 

[Butters78]

I have ulcerative colitis. It used to blow out both ends before i got on my meds.

 

[PEneoark]

There are some tips here:

Drip, Drip, Drip…

In through the threaded end, out through the mouth piece. Think of it this way: the whole point of "blowing out an atty" is to blow as hard as you can to get any primer/liquid out. If you blow hard into the mouth piece, the air is being forced down to the little hole at the bottom connection end. The pressure might damage the coil.

High five Cat. It's no help to me personally, but will help all the new dripper. Great write up!

Sent from my SGH-I747 using Tapatalk 2

 

[sailense]

For cartos, it doesn't really matter since the coil is protected with the polyfill. For an atty, it does matter since some work on the negative pressure to draw juice from a tiny reserve.

TL;DR:
For cartomizer: blow from either end
For atomizer: blow only from threaded end

 

[oplholik]

Go to any drug store and get one of these: Medicine Dispensers - Health at CVS pharmacy

I have been using one for a couple years for blowing out cartos, and atomizers. The threaded end of a 510 fits perfectly in the small end of the rubber fitting. Just pull back the plunger and push it down all the way with force. when you can no longer see a mist coming out of the drip end, you are done. Saves you from getting lightheaded from trying to blow them out. You do have to keep ahold of the bottom of the atty and the rubber piece to keep them from blowing off.

 

[Perrrrito]

This thread can really go downhill quick... I think Steam started it with the third comment haha.

 

[DC2]

For anybody that wants to blow out their 510 atomizers through the threaded end, have fun with that.
I've been blowing mine out through my drip tip for years now with no issues.

I can't speak for other atomizers though, only the 510s because that's all I use.

 

[metrabolic]

I usually just blow out the top into a paper towel and then put a couple drops of vodka in the atty blow again and put it back on my battery and dry burn a little. Been doing it for months and have not broke a atomizer yet. All three are still going strong.

 

[The Ocelot]

That's one of the fun things about vaping - no rules!!!!!

 

[SissySpike]

There are people you can pay to blow it fore you

 

[The Ocelot]

There are people you can pay to blow it fore you

I don't have to. I vape my ProThingy, while my V-thingy blows.

 

[Zbeast08]

Ok.......I knew that my questin would get many witty comments and I actually needed a good laugh today!! I will add to the amusement....I actually ask my wife would she come bow out my atty and got a real funny look but she did it for me and it was not much that came out, anyway......!!!! As I assumed, I got both answers that they can be blown either end. Hope everyone has a great weekend!!

 

[DC2]

As I assumed, I got both answers that they can be blown either end.

This discussion recently took place on another thread.

I recommend reading that discussion, starting here...
http://www.e-cigarette-forum.com/fo...atty-drippers-dying-breed-21.html#post9977346

 

[PEneoark]

ANARCHY!!! lol

Sent from my Nexus 7 using Tapatalk 2