Kanger protank continual dry hits

[JuanC]

So i got one of these clearomizers, is very nice looking, using it on a sigelei Zmax @ 3.7v problem is i keep getting dry hits on it, the tank is new, full of liquid, is properly assembled, it was working fine for a couple hours but now all i get is tonge/nose burning dry hits, i noticed the wick on these is SO short but it was ok, i dont know what is going on, starting to get very dissapointed on this tank.

Also is the original one, the one carried by VZ

 

[Talyon]

Mine work just fine, and I switch out flavors for testing often. I use 100 VG as well.

That being said u can remove 1 of the flavor wicks for more absorption into the coil. You can also out in a longer flavor wick.

GL.

 

[JuanC]

Hmm i think i solved it, is that white plastic thing (silicon?) where the wick is, i removed it and it allowed the liquid to flow but it was too much and started to "drown" on it, so i put it again but more loose and i also did not screw it too tight, seems to be working fine now, thanks!

 

[Soberrider]

Taking one of the wicks out has been working for me.

 

[Discord]

depending on the juice, you want to make sure the balance of air, heat and juice gets right. some things to try would include:

Pulling the top metal pin off of the head and removing the upper wick that doesn't run through (this works for most people)
Removing the silicone gasket (this works for some, but can lead to flooding or leaking)
Reversing the silicone gasket (this works for some, generally avoids the leaking, lets more juice in)
Rebuilding the coil and wick (this takes some practice and supplies, but can produce a far better vape)