KangerTech SUBTANK Mini
- Thread starter Vap0rnomics
- Start date
- th_trl_thread_readers 0
- Status
ahhh, I was going to say.. yeah you're SoL then for any help I could give... some people like to rebuilt the ssocc's etc. I only use the RBA's, the V4 I guess.. small holes in middle and I coil my own wire, using bacon, so not that dissimilar. I was thinking about the too much air issue... have you tried just completely covering one vent and keeping the other open only a tiny bit?
as for the sizzle, I find both tanks that I use the rbas in, sizzle for about 2 second after i'm done. every 5 to 8 inhales or so I take a quick closed vent primer puff... I have the bad habit of chain vaping.
some of my rta with twisted, fused, clapton, etc type coils will sizzle still after letting off the button. Coils don't instantly cool back to room temp after being 400 or 500 degrees is all.
For some reason, my computer is as slow as Molasses right now so bear with me please.
I think you're responding to the issue I'm having with my TTM that I posted on the TTM thread.
How would I cover only one of the TTM holes? I'll try anything!
Best it to learn how to time your draw and button finger so that you keep drawing after letting go of the button. The extra air cools the coil and that helps keep the gunk from cooking onto the coil.
yes I am... since between hubby and I we have 5 of the toptank mini's... I just didn't respond earlier because I was helping someone else. lmfao... I can help with comps too... i'm a geek, what can I say?
I'd try a simple bit of masking tape to start, or electrical tape... hmm actually ducttape would have the best seal and hold.
I'd try a simple bit of masking tape to start, or electrical tape... hmm actually ducttape would have the best seal and hold.
it will still sizzle paul, I always continue to draw a few seconds more, helps prevent fluid build up under the driptip and lovely spills from that.
I did change the drip tip. It helped but it was still not good. I got confused. On the TTM, I was using the Kanger OCC 1.5 coils. On the STM, I was using the Kanger RBA with the Fast TEch prebuilt coils. I think there must be some issue with the prebuilt coils from Fas Tech in the STM. I'm going to change the coil in it and rewick. The prebuilts I got from Fast Tech are supposed to be 1.5 or so ohms, so maybe this is just a faulty coil. I'll report back with results.
Thank you very much!!
just remember, the coils are interchangeable between both tanks, one thing I love about the kangers and other brands that do that.
I love that too. I also like using the non-Nauti Aspire BVC coils in the STMs too and those are considerably less costly than the Kanger STM and TTM coils.
My first attempt with tape wasn't very successful. Then I tried sticking a toothpick in one of the holes. It wasn't very successful either. I already changed the coil on the TTM and put in a 1.5 Kanger OCC, so that's not the issue. This TTM has so much airflow, it's loud when I draw on it. This is just bizarre! I'll try one of the other TTMs I got today and see if it works any better.
- Status
Similar threads
- Locked