Kayfun - Show us your Setup
- Thread starter BaDaBooM
- Start date
- th_trl_thread_readers 0
- Status
Don't see too many rocking the VTR, but here's my go-to out and about setup (goes with me everywhere). I find the heft of the VTR is well balanced by the weight of the KFL. Occasionally I'll load the KFL on my Maraxus or Panzer if I feel like carrying around a lightsaber.
Today's vape...
That the kidney puncher Pyrex tank on the right side?
Sent while on the move with Tapatalk
Yup, did that the day I bought it knowing I would grow tired of the extension tube. After doing it, I have come to realize that I wish more box mods did the "shelf" design as it is way more compact and helps protect the tank.
That is the green plastic M full size tank from fasttech for like 2 bucks. I have all the colors. Got a green small tank section in the kayfun on the Provari in the pic as well.
I do not know. I used white replacement o-rings on my Quartz nano tank which are 15mm. If I were you, I would purchase 15mm, 16mm, and 17mm two of each and try them all until you get the fit you want. Be careful not to break your glass.
you could wrap dental floss under the o rings a bit to tighten them up. Gotta use the right amount depending on how tight you need it
Kayfun with new pyrex tank from kidney puncher. Anyone know how to make the seals tighter?
Sent while on the move with Tapatalk
3.1 clone in drip mode, Magneto ..350, shortie wide bore drip. Short but powerful!
I've been lucky using teflon tape. Just do a couple of wraps over the oring channels and use an Xacto to cut the excess; then slide the orings over.
Last edited:
It's by Ehpro, very nice for a clone.
Kayfun Lite Plus Kit Gold Black Rose Gold Atomizer RBA Kayfun Lite Kit by Ehpro | eBay
So shat you're saying is you don't like the kayfun right?
Sent while on the move with Tapatalk
- Status
Similar threads
- Locked