Keep getting Atomizer Short message on my eVic with twisted wire. HELP!!!!

[3angryinches]

I have an AGA-T+. I rolled a 400 ss wick with no problem. I made a twisted wire of 32 gage. I did 3/4 wraps and it wouldn't fire. I keep getting a short message on the evic. I then tried a regular wire with 4/5 wraps and it fires up fine at 2.0 Ohms. Any suggestions?

 

[kiwivap]

I have an AGA-T+. I rolled a 400 ss wick with no problem. I made a twisted wire of 32 gage. I did 3/4 wraps and it wouldn't fire. I keep getting a short message on the evic. I then tried a regular wire with 4/5 wraps and it fires up fine at 2.0 Ohms. Any suggestions?

What ohms was the 3/4 wrap at? You may have been too low resistance for the Evic. Or your coil may not have been stable - and the Evic detected the short(s).

You may want to read this thread - about amp limits with Evic batteries:
http://www.e-cigarette-forum.com/fo...m-genesis-work-so-well-ego-c-passthrough.html

 

[Izan]

What does the coil read off the wick?
I

 

[scuzzy]

Make sure the wick isnt touching the base of the tank,

 

[3angryinches]

What ohms was the 3/4 wrap at? You may have been too low resistance for the Evic. Or your coil may not have been stable - and the Evic detected the short(s).

You may want to read this thread - about amp limits with Evic batteries:
http://www.e-cigarette-forum.com/fo...m-genesis-work-so-well-ego-c-passthrough.html

Sorry, I don't remember the ohms reading. I'll read the link you provided. Thanks for the help.

 

[3angryinches]

Make sure the wick isnt touching the base of the tank,

I'll try that. I don't remember if it was touching or not. Thanks for the help.

 

[3angryinches]

What does the coil read off the wick?
I

I don't remember the Ohms reading.

 

[jazon1]

i was having the same issues with my mini provari and a aga-t only way i was able to get it to run right was with using the roley paper trick to insulate the wick from the tank no matter how much i tried to oxidize the wick it still seamed to make some contact.

 

[scuzzy]

try 5/6 cycles of oxidising the coil end on the wick, I do this if I get errors, usually works

 

[erawtik]

Same prob just oxidized the wick few more times fixed it

Sent from my PG86100 using Tapatalk 2

 

[mce_fr]

Hi guys,

When I use my eVic with the maximum voltage the vapor starts to smell like burnt, did you guys ever experience this ?

 

[jazon1]

yes its because you are burning your eliquid from having the voltage to high for your atomizer