LT now or Provari later?

Status
Not open for further replies.
So I've been contemplating this for a couple of days now and I have enough to get a LT as right this post or should I wait about a month or two to get a Provari? You see I just got a new job working as a pharmacy tech at a hospital and will be making more money than I am now which is basically none and I start on Monday, but I'm really starting to get over my twist and want to make the switch to a real vv asap.
 

Scottinboca

Vaping Master
ECF Veteran
Verified Member
Oct 14, 2011
3,678
3,775
Planet Vapton
IMO, I'd go with a LT if that's what you can afford. There's nothing wrong with the LT, they are cheaper and work great. Save up and get the ProVari later if you still want it. I have a ProVari and I love it, but I use genesis attys and it helps with ohm checking and other issues that the LT won't.:2c:
 

JKVaper

Senior Member
ECF Veteran
Verified Member
Sounds like the same issue I have recently run in to. Since I could not afford A ProVari yet I purchased a young june Lavatube kit from Vaporbeast.com, so far am not regretting it......still have Ego 650Mah pass-through and a Ego 1000 twist as backups though, in case something goes awry with the LT. I will get a Provari eventually, when finances permit.
 

18SixFifty

Super Member
ECF Veteran
Aug 14, 2012
532
1,319
Michigan
Variable Voltage 1.5 Mod Kit - Smoke Anywhere For Penny's, LLC Store

Buy this one. It's the good Young June model, it has the better 3amps, it does check your resistance (ohms) and battery power, pulse modulation etc. It's the good one. On top of this people who say it will gather dust are wrong. Many people who spend big bucks on a provari don't want to take it out and about with them. Furthermore, the batteries and charger will work fine for a provari if (and I do mean if) you decide to upgrade.

So it's not a waste at all, you get a great APV that can be used as your primary or backup and the batteries and charger you will need to buy anyway. The two atties are just a bonus and will work great for testing juices on. The batteries, atties and charger almost pay for the entire package anyway.
 

18SixFifty

Super Member
ECF Veteran
Aug 14, 2012
532
1,319
Michigan
I thought the new chrome LTs were the same as lambos?

The lambos are L rider and the Chrome Lt's are young june. (at least some of them are) The difference is the Young June has a 3amp limit, which is higher, they can also check resistance (ohms) and they have PWM pulse width modulation.

A PBusardo Review - In Depth Chrome Lava Tube Comparison - YouTube

This is a great video although it's not 100% correct because there are actually many more variations.

You can get the same Young June electronics and connectors without going chrome.
 

Baditude

ECF Guru
ECF Veteran
Apr 8, 2012
30,394
73,077
71
Ridgeway, Ohio
I always thought the Provari was too expensive, but now that I finally got one recently I wish that I had gotten it much earlier.

It is such a well-built, finely machined device that's built to last a LONG time. It screams quality. Factor in that should it ever need servicing, Provape will be right there to do it. It's one of the safest mods you can own with its built-in inteligence. Built-in battery tester and built-in ohms tester. Gently alerts you when your battery is getting low. Oh, and its variable voltage...one of the couple of mods available that will provide precisely what you dial in, everytime.

Just my opinion, but the way I looked at it, the Chinese-made mods can do much of what a Provari can do, and at an initial much lower cost. But once the warranty is out, who is going to repair it? Will this mod provide me with all the safety features that the Provari can? Can this mod deliver the same vape from from start to finish, every time, during the duration of each battery? Probably not.

You may not need a Provari now. But chances are you will end up with one eventually like I have. Only you can decide whether to get one sooner or later.

 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread