Whats the best way? I've successfully done it once, but it looked terrible. I tried it a second time and couldn't get the positive wires to catch.
Microcoil build on Origen?
- Thread starter withravenoushunger
- Start date
- th_trl_thread_readers 0
- Status
Here's how I set mine up. I rotated the positive screw so the holes are pointing in the direction I want. I build my coils with the legs pointing > and <. Work on the positive post first, and adjust the coils to the desired height. Then bend the legs to reach the deck and screw the negative end of the coils.
Here's the end result, not perfect but good enough for me.
Here's the end result, not perfect but good enough for me.
i didn't have to rotate my positive screw, but they positive post has holes in it so it shouldn't be a problem getting your wire through from each side
here's how mine is currently set up
i've tried it with vertical and horizontal coils, and they both seem pretty good
i recommend using 1 continuous wick so the wells are drained evenly
using drill bits to position the coils like player one did helps a lot when screwing the posts down and maintaining your coil's shape and position
here's how mine is currently set up
i've tried it with vertical and horizontal coils, and they both seem pretty good
i recommend using 1 continuous wick so the wells are drained evenly
using drill bits to position the coils like player one did helps a lot when screwing the posts down and maintaining your coil's shape and position
Are you supposed to put both wires through the hole? I wasn't able to get them both to tighten so I wrapped one around the post. I've got it working pretty good now. Not the best looking thing though. Thanks.
It's adjustable to a certain extent. If you loosen the nut that holds the positive screw, you can adjust it. I am able to put both coil legs through the hole on the positive screw. I am using 27 ga by the way with room to spare.
- Status
