I've been running them since the end of May and cleaning with a Wal-Mart ultrasonic jewelry cleaner with great results.
Finally, one of my atties went south. The draw was ridiculously hard but, otherwise, it worked. I cleaned it relentlessly, to the point that the protective, clear finish and CigNot lettering were gone, leaving the bare stainless. Boiling, blowing, disassembly with dry-burning and ultrasonic cleaning overnight didn't fix it so I considered it dead.
Based on the symptoms, the thought occurred to me that something might be stuck in the air path so I ran hot water through it and blew it out backwards (opposite of inhale flow).
Well, shoot! The reverse blow-out cleared it and I'm vaping it right now, good as new!
With good cleaning, these things seem to last quite a while. I just got four more atties from CigNot so should be good-to-go for quite a while...
Thanks,
Lee
Finally, one of my atties went south. The draw was ridiculously hard but, otherwise, it worked. I cleaned it relentlessly, to the point that the protective, clear finish and CigNot lettering were gone, leaving the bare stainless. Boiling, blowing, disassembly with dry-burning and ultrasonic cleaning overnight didn't fix it so I considered it dead.
Based on the symptoms, the thought occurred to me that something might be stuck in the air path so I ran hot water through it and blew it out backwards (opposite of inhale flow).
Well, shoot! The reverse blow-out cleared it and I'm vaping it right now, good as new!
With good cleaning, these things seem to last quite a while. I just got four more atties from CigNot so should be good-to-go for quite a while...
Thanks,
Lee