• This forum has been archived

    If you'd like to post a thread, post it here instead!

    View Forum

Nebraska Vaping

Status
Not open for further replies.

Jakersvape

Vaping Master
ECF Veteran
Verified Member
Oct 27, 2012
6,795
1,124
43
Lincoln, NE
That's a bafflement, if I do say so..

So after a bit longer usage on the volt setting I had to turn it down to about 3.7 volts to get a good non burnt taste....do you know of the vamo uses rms? It doesn't have pwm??

Sent from my DROID X2 using Tapatalk 2
 

PittBoss

Vaping like a boss
ECF Veteran
Verified Member
Mar 27, 2012
11,961
1,591
Lincoln, NE
The volts seem a little more comparable to the volts on my zmax....I can take both up to about 4.4 volts before it starts burning

Sent from my DROID X2 using Tapatalk 2

That sounds a bit more accurate..at 6 watts on a 2.6 ohm nova would come out to what in voltage? Not that much, no? Damn bourbon..
 

PittBoss

Vaping like a boss
ECF Veteran
Verified Member
Mar 27, 2012
11,961
1,591
Lincoln, NE
So after a bit longer usage on the volt setting I had to turn it down to about 3.7 volts to get a good non burnt taste....do you know of the vamo uses rms? It doesn't have pwm??

Sent from my DROID X2 using Tapatalk 2

Same features as the ZMax V2.. Can switch between RMS and AVG..I do believe it runs on PWM as well
 

Jakersvape

Vaping Master
ECF Veteran
Verified Member
Oct 27, 2012
6,795
1,124
43
Lincoln, NE
That sounds a bit more accurate..at 6 watts on a 2.6 ohm nova would come out to what in voltage? Not that much, no? Damn bourbon..

If I did it right, 3.7 volts on a 2.6ohm atty would be 5.3 watts, 4 volts would be 6.2 ohms....

Sent from my DROID X2 using Tapatalk 2
 

PittBoss

Vaping like a boss
ECF Veteran
Verified Member
Mar 27, 2012
11,961
1,591
Lincoln, NE
Might have to do some digging to figure out how to switch from rms to avg......

Sent from my DROID X2 using Tapatalk 2

If you press and hold the '+' button for more than 10 seconds and the display should read either 001 or 002. 001 is RMS and 002 is AVG. If you then press and hold again, for however long, it should switch it.
 

Jakersvape

Vaping Master
ECF Veteran
Verified Member
Oct 27, 2012
6,795
1,124
43
Lincoln, NE
If you press and hold the '+' button for more than 10 seconds and the display should read either 001 or 002. 001 is RMS and 002 is AVG. If you then press and hold again, for however long, it should switch it.

Cool....so I'm guessing pressing the '-' button does the same thing....it says the same thing

Sent from my DROID X2 using Tapatalk 2
 
Status
Not open for further replies.

Users who are viewing this thread