You are a champ!
Always willing to take one for the team....
Sent from my DROID X2 using Tapatalk 2
You are a champ!
That's a bafflement, if I do say so..
The volts seem a little more comparable to the volts on my zmax....I can take both up to about 4.4 volts before it starts burning
Sent from my DROID X2 using Tapatalk 2
So after a bit longer usage on the volt setting I had to turn it down to about 3.7 volts to get a good non burnt taste....do you know of the vamo uses rms? It doesn't have pwm??
Sent from my DROID X2 using Tapatalk 2
Always willing to take one for the team....
Sent from my DROID X2 using Tapatalk 2
That sounds a bit more accurate..at 6 watts on a 2.6 ohm nova would come out to what in voltage? Not that much, no? Damn bourbon..
Same features as the ZMax V2.. Can switch between RMS and AVG..I do believe it runs on PWM as well
Howdy crew what's going on
Sent from my LG-LS840 using Tapatalk 2
You are a good man!
If I did it right, 3.7 volts on a 2.6ohm atty would be 5.3 watts, 4 volts would be 6.2 ohms....
Sent from my DROID X2 using Tapatalk 2
Howdy crew what's going on
Sent from my LG-LS840 using Tapatalk 2
I am mathing poorly tonight..lol..Maybe another glass will do me some good!
Might have to do some digging to figure out how to switch from rms to avg......
Sent from my DROID X2 using Tapatalk 2
There's no I in team, right??
Sent from my DROID X2 using Tapatalk 2
Howdy, partner! How goes it?
Better have 2!
Sent from my DROID X2 using Tapatalk 2
not too much going on, kicking back watching some basketball
Sent from my LG-LS840 using Tapatalk 2
If you press and hold the '+' button for more than 10 seconds and the display should read either 001 or 002. 001 is RMS and 002 is AVG. If you then press and hold again, for however long, it should switch it.
Jen took my other one![]()