• This forum has been archived

    If you'd like to post a thread, post it here instead!

    View Forum

Nebraska Vaping

Status
Not open for further replies.

PittBoss

Vaping like a boss
ECF Veteran
Verified Member
Mar 27, 2012
11,961
1,591
Lincoln, NE
The constant firing has only happened probably 5 or 6 times since I've had, so just over a week.....what was really bugging me was the not firing....or where I would push and hold the button and it would fire for a second and then stop. I would either have to kinda push harder or wiggle it around a bit. Since loosening the cap the button feels a lil different and it's fired every time so far....we'll see if it keeps it up.

Sent from my DROID X2 using Tapatalk 2

My LT does the "not wanting to fire" thing..never the "I don't wanna stop firing". I have to push the button at a certain angle and then it works fine, but it's more of a clean and re-position the contact to the "trigger" rather than not enough room, or whatever the issue is with the ZMax..
 

PittBoss

Vaping like a boss
ECF Veteran
Verified Member
Mar 27, 2012
11,961
1,591
Lincoln, NE
Think I might have to redo my coil.....after messing with it a bit I think only one leg is heating up, and burning the rubber grommet on the bottom

Sent from my DROID X2 using Tapatalk 2

Hmmm..I always wondered if that grommet even 'needs' to be on there..
 

PittBoss

Vaping like a boss
ECF Veteran
Verified Member
Mar 27, 2012
11,961
1,591
Lincoln, NE
I don't know if the center pin would fit in there right.......I might have to try bit out in a bit

Sent from my DROID X2 using Tapatalk 2

Oh yeah..Don't think it will. I'm pretty sure I used NR wire to go the length between coil ends and bottom post.. Sounds like something I would have done.. I haven't played around with the Nova since Jen took it over and I have the other RAs..
 

Jakersvape

Vaping Master
ECF Veteran
Verified Member
Oct 27, 2012
6,795
1,124
43
Lincoln, NE
Oh yeah..Don't think it will. I'm pretty sure I used NR wire to go the length between coil ends and bottom post.. Sounds like something I would have done.. I haven't played around with the Nova since Jen took it over and I have the other RAs..

I didn't have any NR wire, so I just doubled the legs up and twisted together.

Sent from my DROID X2 using Tapatalk 2
 

Jakersvape

Vaping Master
ECF Veteran
Verified Member
Oct 27, 2012
6,795
1,124
43
Lincoln, NE
The co-op for the aga-t+ went up a little bit ago. I think it's $24. It's being run by Matthew, who said he goes by ivisi(??) on here. It closes the 18th,but said he may close earlier. He's shooting for 100. I think it said it includes the aga-t+, Pyrex tank, and spare parts kit.
I might get in on it and give these things a try....

Sent from my DROID X2 using Tapatalk 2
 

PittBoss

Vaping like a boss
ECF Veteran
Verified Member
Mar 27, 2012
11,961
1,591
Lincoln, NE
The co-op for the aga-t+ went up a little bit ago. I think it's $24. It's being run by Matthew, who said he goes by ivisi(??) on here. It closes the 18th,but said he may close earlier. He's shooting for 100. I think it said it includes the aga-t+, Pyrex tank, and spare parts kit.
I might get in on it and give these things a try....

Sent from my DROID X2 using Tapatalk 2

I may have to go check it out..
 
Status
Not open for further replies.

Users who are viewing this thread