Need Help Please

Status
Not open for further replies.

robcope

Senior Member
ECF Veteran
Jul 3, 2010
250
127
Texas
I can only assume you are either using the ego-t or ego-c. How long are you waiting between pulls? Sometimes it takes a,bit for the juice to get into the atty. I usually prime the atty with a few drops of juice then put the tank on and that seems to help. Let us know how it goes.

Sent from my ASUS Transformer Pad TF300T using Tapatalk 2
 

restatelady

Senior Member
ECF Veteran
Verified Member
May 21, 2012
97
40
Florida
I can only assume you are either using the ego-t or ego-c. How long are you waiting between pulls? Sometimes it takes a,bit for the juice to get into the atty. I usually prime the atty with a few drops of juice then put the tank on and that seems to help. Let us know how it goes.

Sent from my ASUS Transformer Pad TF300T using Tapatalk 2

Thanks sooo much!! It worked. No more burnt plastic taste.
 

moishesmom

Ultra Member
ECF Veteran
Apr 27, 2012
1,257
3,393
west bloomfield
I just received today my ego 650 mah. I charged the battery and filled the tank all according to instructions. After puffing a couple of times I got an awful burnt taste. So, I removed that tank and filled another one and again the same thing. An awful burnt taste. What did I do wrong?

Hi...Just want to know if you cleaned the primer (oil) off the atty -if not that could be giving you that lovely taste.
 

Riverboat

Vaping Master
ECF Veteran
Verified Member
Feb 15, 2012
4,014
3,111
Arizona
Yea, word is the attys cone with primer for performance, best to give it a couple dry burns get that stuff outta there, just don't over do it and fry the thing..

Sent from my PG86100 using Tapatalk 2

Been a direct dripper for 2 1/2 years.. Dont dry burn a new atty. yuck... Insteaed blow it clear of primer into a paper towel..
Next drip 3 drops of your e-liquid... Vape 3-4 draws... Blow it clear again, redrip 2-3 drops. Vape, most of the primer taste should be gone......
 
Last edited:
Status
Not open for further replies.

Users who are viewing this thread