Hey guys and gals I'm just getting started in the vape community and I'm having a little trouble getting set up idk if I packed my Cotten good enough through my coils but it's a smok r200 and my tip is a tobeco turbo but when I drag off of it seems to crackle more than it should and it spits juice up to my tip idk why this is happening but any help would be greatly appreciated thanks!
- Status
Search youtube on how to do the scottish roll 
My advice would be.
1. Get a longer drip tip
2. Try to angle your coils
3. Put less PG in your juice.
4. use higher number coil gauge. or less surface area coil
5. .... your cotton closer around and towards the top of your coil but dont completely cover the top your coil
6. Throw out that particular juice.
1. Get a longer drip tip
2. Try to angle your coils
3. Put less PG in your juice.
4. use higher number coil gauge. or less surface area coil
5. .... your cotton closer around and towards the top of your coil but dont completely cover the top your coil
6. Throw out that particular juice.
Some of my coils gurgled and spit and I found I was not vaping them hot enough to more completely boil the e-liquid. You might try raising the watts in power mode or increasing the temp in temp mode. I tend to like a cooler vape, so this was a learning experience for me. I increased in small increments until the gurgling stopped.
Photo of the build would be very helpful.
It may be the wicking, or may be the position of the coils - it's solveable though!!
It may be the wicking, or may be the position of the coils - it's solveable though!!
Sounds like you do not have enough cotton inside the coil.
You want the cotton tight but still able to slide. Just a little resistance to the coil.
When tge Juice is put on the wick the cotton will swell up and fit the coil perfectly.
- Status
Similar threads
