Need help with APV cartomizer question

[uncfan2001]

I just purchase a Vamo V3 and need to know if the Smoktech Dual Coil 510 carts that I purchase will work with the device. They are 1.5 +/- .2 ohms. Also suggestions with voltage and wattage settings would be helpful.

 

[burrito]

Yes they will. Dont go to high on the Volts or you'll fry the juice, throat and coil. I've seen people use them on Provari's, Vamos and Max's all day long and they seem to dig it. Go to tasteyourjuice.com and he has a chart on there with a Volt and Ohm chart.

 

[suspectK]

Yes, they'll work fine. Dual coils can take a lot of extra heat, but I'll advise you to start around the same area you would with a single coil and move upwards, 3.3-3.5 Volts. When I use 1.5 dual coils, I tend to stick around 4.5 Volts. So starting at 7.3 Watts to make sure it is a dual coil and all...and move on up to 13.5 Watts..you may even want it higher than that if you like it warm. Just be mindful when you're using it a lot. That extra heat will really need a good, flowing wick.

 

[ItTechy]

Yes they will work fine.

On a VV mod use no more 4.2 volts or as burrito posted you can fry the juice and or coil.

I would start out using them at like 3.7 - 4.0 volts....IMHO

See Suspect' post also, all good information !

I just purchase a Vamo V3 and need to know if the Smoktech Dual Coil 510 carts that I purchase will work with the device. They are 1.5 +/- .2 ohms. Also suggestions with voltage and wattage settings would be helpful.