Need Help_(Newb)

[heavenzboi]

Sup guys,

I just started vaping the mech mod_(about 2weeks)
I would like to know how I can get my vape cooler ?
Im using kayfun and too hot or warm for me. and would like to have more cooler vape.
saw some post about drilling the kayfun, but dont want to mess it up with my kayfun.
Please help guys, Thanks in advance!

 

[Btsmokincat]

Build a 1.5 to 2.5 ohm coil. The higher the ohms the cooler the vape on a mech (you will probably be sacrificing vapor amount and how quick it hits though). If you are already in that range then it is what it is on a mech, you'll have to put in on a regulated mod and use lower voltage or wattage.

I drilled my EHPro Kayfun Lite to 5/64. You have to remove the positive pin which connects to the positive block on the deck. Drill through the airhole with a nice sharp bit then wash and reinstall the positive pin and block. Makes a big difference in vapor amount!

 

[Despraci]

Try a different drip tip too. A longer non metal drip tip will not conduct as much heat.

 

[tayone415]

You can try more wraps for hiring ohms or use thinner wire for more resistance or a wider bore drip tip.

 

[heavenzboi]

I dont know how to build a coil yet! so i will go to my local store and change my coil.
And i have EHPro Kayfun too! I really want to drill my airflow holes too!!!!!!!!!
Thanks for your comment. helped alot!

 

[heavenzboi]

You can try more wraps for hiring ohms or use thinner wire for more resistance or a wider bore drip tip.

So higher ohms will give me cool vape ?

 

[koepfsm]

Drill your cap out to get more air flow , it will give you more vaper plus cool things down.

 

[tayone415]

So higher ohms will give me cool vape ?

Yes, cooler vape but almost always less vapor production.

 

[Grimwald]

Yes...more wraps in your coil for higher ohms will cool the vape. I use 6 wraps of 32ga on a 1/16" drill bit for 1.9 ohms.

The standard drip tip on the ehpro kayfun has a narrow hole, which concentrates the vapor...but it does help the kayfun to feed correctly. I prefer to change mine to a wider bore tip to make it a little easier draw and a little more air. Sometimes a longer fatter acrylic tip which cools the vapor more. If I'm having wicking issues (burnt taste) which can happen for me if I fill it too full, I swap back to the original tip for awhile.

 

[DaveP]

I'm vaping a 1.6 ohm coil at 3.4v most of the time. I'm not a cloud chaser, but that's not what the Kayfun is for, anyway. With a mech, at higher resistance you will get a cooler vape and still get good vapor and flavor. I'd look around for a variable voltage/wattage mod. It's nice to have a volume control for vapor production. You can crank it up or down to match your taste.

 

[Rat2chat2]

You already have the answer to your question but I just wanted to

you to ecf heavenzboi . So glad you are here. The people here are so wonderful and helping you with just anything. Have fun and happy vaping to you.

 

[heavenzboi]

Thank you all for the HELP!!!
I am on my way to my local vape store to rebuild my coil, and will discuss with them about drilling the air hole or make bigger air hole!
Will comment after!!

again thanks for the help all!!!!!!!!!!!!