New Genesis type atomizer by DID!

Status
Not open for further replies.

Cloud Wizard

Ultra Member
ECF Veteran
Verified Member
Feb 24, 2012
2,315
5,684
Somewhere in PA on my Ultra Limited
Naturally Extracted tobacco (NET) "bases" are all that I vape. Some have added flavorings and some don't. I've been through the majority of them and some approach a deep cigar or pipe flavor. Heather's Purity selection is a great place to begin and are among the less "tobacco-ey" tasting of the NETs. The very best IMHO, are made by:

GoodeJuice
Heather's Heavenly Vapes
Want2Vape
Ahlusion
QuickNic
Plume Room
VapeRite

Mr. Mann is a very good source of info on these...

Cool! Thx for the list (added to my notes for future sampling). I'm trying to burn through my buckets of older juices but will definitely try them all eventually. Problem is that I'm starting to find a lot of them I like - was much simpler when I only liked a couple :laugh:
 

MiriamWTH

Moved On
ECF Veteran
Verified Member
Aug 9, 2011
778
2,889
55
Tilburg (Netherlands)
I've never owned a Provari but my understanding is that they are fussy with any stainless mesh wicks because they throw up an error code at the first detection of each little "micro-short". Makes sense to me... I saw advice once from a Provari user that it's easier to setup their mesh wick on an unregulated "mechanical" mod, or the more forgiving Buzz Pro, then transfer the atomizer to Provari after any shorts have been cleared.

I will probably do it the other way around, set it up on my Provari (I am well used to that and don't really have issues with that) and then transfer it to the Poldiac so I am sure there are no shorts.
 

MiriamWTH

Moved On
ECF Veteran
Verified Member
Aug 9, 2011
778
2,889
55
Tilburg (Netherlands)
You cant work out the shorts if the Pro wont fire the atty to show you where they are :)

It is the only battery holder I have.
I never had issues with it in setting up the DID. You wait until the error message is gone (a few seconds) poke the coils and try again (always making sure you start at the lowest voltage setting).
 

Cloud Wizard

Ultra Member
ECF Veteran
Verified Member
Feb 24, 2012
2,315
5,684
Somewhere in PA on my Ultra Limited
You cant work out the shorts if the Pro wont fire the atty to show you where they are :)

If it is that bad, I'd pull the wick and oxidize it again (faster than trying to sort out with nudging a coil). That's one of the benefits of wrapping a coil so that the wick can twist out/in.
 

Jim Damianidis

Unregistered Supplier
ECF Veteran
Apr 29, 2012
1,110
5,576
Greece,Athens
www.mmvapors.com
Hi there!!
I am tired and very presured
I try to be OK for the say after tomorrow!
Believe me that it is not easy as I have to check everysingle butoon fanctionality!


one foto?

20121218184821988.jpg
 
Status
Not open for further replies.

Users who are viewing this thread