New Youde RTA the Bellus
- Thread starter mecca7979
- Start date
- th_trl_thread_readers 0
- Status
You are right in the range I like! For me .3 to .4 ohms vapes well in that range. I currently have a .34 ohm build at 35 watts in my Bellus. It's a nice warm - not to hot - vape with a short ramp up time.
Yeah sorry oops. I run pretty much the exact same build in most of my tanks - dual 26/34 kanthal claptons, 2mm ID, 6 wrap which always comes out in the .32 to.38 range.
Not a bellus but it's the same build...
I'm running a 316L SS build at 35W in one Bellus. Dual, 2.5mm ID, 26g.
Yeah sorry oops. I run pretty much the exact same build in most of my tanks - dual 26/34 kanthal claptons, 2mm ID, 6 wrap which always comes out in the .32 to.38 range.
Not a bellus but it's the same build...
Is that build juice hungry?
Evil coil killer indeed! Looking at any virus coil after about 10 ml will make wonder why your teeth aren't stained!
Depends on what it's in. In the bellus, it is a little bit, not too bad. In a Mutank (the tank in the picture) it absolutely guzzles the juice but in a Billow V2 it's no worse than a regular micro coil build. Other factors like airflow, juice channel size, wattage and viscosity can affect consumption too.
If I dual coil my Bellus, I can see the juice level drop from a few drags at 22 watts.
Of course I have pretty good vision and am also a whiny juice miser...
Of course I have pretty good vision and am also a whiny juice miser...
With my go-to build, that would be about .45-.55ish Ω net. #26, 7wraps each, 2.5mm ID, rayon all the way.
- Status
Similar threads
