Nimbus help...
- Thread starter Akasticker
- Start date
- th_trl_thread_readers 0
- Status
So I pushed the coil down further and it's below the airhole level but it's still not good, I dry burned the coil and it lit up perfect but it keeps browning the wick on one side, and I've tried using even less cotton.... I give up
Are you dry burning the cotton wick? That will ruin cotton immediately and cause a horrible burnt taste.
Last edited:
No no, I dry burned the coil to test it before putting the cotton in. I'm gonna go to the vape shop here in Philly tomorrow and have someone do a build for me and see how that works out
Best of luck! Hopefully they can get you set up with something that is working well!
So my local vape shop talked me into a sub ohm build. They did dual coil 3 wraps of 28 gauge. They also sold me a 30 amp sony battery. This thing rips now, but the top cap gets so damn hot after a few hits. Idk this is the build they do for everyone and refer to it as the "standard build".... It ohms out at like .3. What do u guys think?
So my local vape shop talked me into a sub ohm build. They did dual coil 3 wraps of 28 gauge. They also sold me a 30 amp sony battery. This thing rips now, but the top cap gets so damn hot after a few hits. Idk this is the build they do for everyone and refer to it as the "standard build".... It ohms out at like .3. What do u guys think?
well a 0.3 ohm build is a sub-ohm build, its pretty low and it does entail really understanding the consequences and dangers involved. The batt upgrade is good but there are still things to look out for. And yes the top cap will get hot coz it does generate a lot of heat. Personally that does not fall under a standard build, I owuld have like it at around 0.4-0.5ohms, maybe one additional wrap each coil for peace of mind
- Status
Similar threads
