I just got my npro 2 days ago.  Love it, hooked, can't get enough, stopped smoking analogs for good!
 
Anyway, this morning when I went to pop on a new cart, I noticed that the wire mesh above the atomizer was gone. Probably my fault from twisting the old cart to get it off or blowing it out with compressed air, stupid I know. Just the metal piece it sits on was left. I put the cart on anyway but think the pot was getting way too wet and was scared that the nylon would burn so I didn't smoke it much.
 
My JC VG sample pack came in the mail so I was just dripping it a drop at a time into the atomizer pot and it seems to work okay.
 
My question...is that metal mesh above the atomizer required, or am I fine dripping like I described? I'm not worried about voiding my warranty, am ordering a new atomizer, have DSE901b on the way and just want to be safe and make sure it lasts until then.
 
And like others, I wish I would have found this forum BEFORE I started ording stuff!
 
Thanks much!
	
		
			
		
		
	
			
			Anyway, this morning when I went to pop on a new cart, I noticed that the wire mesh above the atomizer was gone. Probably my fault from twisting the old cart to get it off or blowing it out with compressed air, stupid I know. Just the metal piece it sits on was left. I put the cart on anyway but think the pot was getting way too wet and was scared that the nylon would burn so I didn't smoke it much.
My JC VG sample pack came in the mail so I was just dripping it a drop at a time into the atomizer pot and it seems to work okay.
My question...is that metal mesh above the atomizer required, or am I fine dripping like I described? I'm not worried about voiding my warranty, am ordering a new atomizer, have DSE901b on the way and just want to be safe and make sure it lasts until then.
And like others, I wish I would have found this forum BEFORE I started ording stuff!
Thanks much!