Mouth to Lung vaper here, anyone know of any tanks that don't leak besides the cubis?
No leak tanks?
- Thread starter Uniphish
- Start date
- th_trl_thread_readers 0
- Status
Just wanted to welcome you to the forum...
. I use a GS air tank and also an Ecto, which is sort of a generic one. Neither leak for me.
. I use a GS air tank and also an Ecto, which is sort of a generic one. Neither leak for me.I've had a nautilus mini for a while now and can honestly say it's never leaked one drop. I carry it around in my coat pocket, bouncing it around daily and keep expecting it to leak a little, but it never has so far. I'm sure others have had different results. Maybe I just got a good one, but I'm going to get another one, and maybe the 5 mil version also. I do hate a leaking tank.
never had any issues with my nautilus leaking where as every kangertech tank i have ever owned seem to leek out of every orifice. the cubis i find has a better flavor than the nautilus.
Pick one you like and buy it. If it works out for you, buy a couple more.
I've had great luck with Subtank Minis, while others swear they just dump juice.
I have 3 Crown tanks that never have leaked with factory coils and leak when I screw up the wicking using the RBA. Others will tell you that the Crown is second only to pouring straight out of the bottle when it comes to losing juice.
I have no idea what would make either tank leak when using factory coils as mine get taken on planes, thrown into the cup holder on cross country trips, fall to the floor occasionally, just no special babying.
I've had great luck with Subtank Minis, while others swear they just dump juice.
I have 3 Crown tanks that never have leaked with factory coils and leak when I screw up the wicking using the RBA. Others will tell you that the Crown is second only to pouring straight out of the bottle when it comes to losing juice.
I have no idea what would make either tank leak when using factory coils as mine get taken on planes, thrown into the cup holder on cross country trips, fall to the floor occasionally, just no special babying.
All tanks leak if used or set up improperly. Tanks need that vacuum/negative pressure in the tank to stop juice from flowing through the coil into the air camber and out the air holes. That's why it's very important to make sure all seals and o-rings are doing their job.
My Nautilus Minis have leaked and it's always because the seal at the top of the glass and the part that the drip tip goes into isn't sealed correctly. I replaced my glass tanks on my Nautilus Minis with the one piece stainless steel tanks and they haven't leaked since.
My Nautilus Minis have leaked and it's always because the seal at the top of the glass and the part that the drip tip goes into isn't sealed correctly. I replaced my glass tanks on my Nautilus Minis with the one piece stainless steel tanks and they haven't leaked since.
Triton 2 has not leaked a drop however I do not have problems with my nautilus either. I do think the new Triton is fab.
I"ve seen people comment that the Triton tends to leak, but I've had mine a few months, it's the only thing I vape from, and the *only* time I've had a leak is when I've been trying to push a coil well past where I knew it should have been changed. Somehow this messes up something with the flow through the device, and I'll get (small) leaks from the upper vent if I set it down in that condition.
I've never had a leak from a coil that was not worn out, and I love everything about this tank. Unlike the Triton 2, you can't fully disassemble it, but I think there have been some different complaints from the Triton 2, so pick your poison I suppose.
I've never had a leak from a coil that was not worn out, and I love everything about this tank. Unlike the Triton 2, you can't fully disassemble it, but I think there have been some different complaints from the Triton 2, so pick your poison I suppose.
Thanks. All my tanks leak, trying the cubis. Was thinking of a Triton 2 if th cubis doesn't work. Living in a state with lots of variances elevation wise is what does it in my case as its a known problem.
In terms of no leaking and mouth to lung, the only thing that comes to mind the Sense Hydra tank. It's a nice small mouth to lung, but note that the 1.8 coil is an interesting one and goes up to something like 15-50W. I usually vape mine around 20W; anything less doesn't produce much vapor. Worth looking into.
It's never leaked on me, and no juice in my mouth. I've had better for flavor, but it's really dependable and simple. Sort of like a super Nautlius mini.
It's never leaked on me, and no juice in my mouth. I've had better for flavor, but it's really dependable and simple. Sort of like a super Nautlius mini.
I have three nautilus mini's and none of them have ever leaked. I have GS airs, and recently a Triton mini and kabuki clone from fasttech that don't leak, all mouth to lung tanks. It doesn't surprise me than some here have had a leak, quality control is something that is missing sometimes
I have extensive experience with Kanger Subtank mini's and the plus model...mine have never leaked with factory coils. I've only had the Uwell Crown for a month or so, and they have never leaked on me either...using both top fill and bottom fill. Checking your tanks for a tight seal is pretty easy, just plug up the airflow holes with your fingers and draw on the tank, if you can pull some air, you have an bad seal somewhere. If you use your factory coils beyond their lifespan, they can also start leaking...
- Status
Similar threads
